Planika WallFire User manual

Copyright Planika Sp. z o.o. www.planikafires.com i0730#03 02.12.2014 1
INSTALLATION MANUAL
WallFire
H
x 1
B
x 1 x 1
C
A
x 1
H
x 1 x 1
IF
x 2
E
x 2
x 1
G
D
x 4
• Do not install the device in areas with a capacity of less than 70 m
3
/ 2472 ft
3
(27 m
2
/
291 ft
2
with a height of 2.6 m / .53 ft).
• Do not install the device in areas of large drafts of air, near fans, vents, etc.
• Do not place the device in close proximity to sources of humidity.
• It is obligatory to have a carbon-dioxide (CO
2
) or dry chemical extinguisher placed
nearby the device.
• The room in which the device will be installed must have efficient ventilation to ensure
air exchange in the room at least once per hour.
• Do not start the device before installation.
• Do not fill the fuel tank prior to installation
.
mm] in]
H 359 14
1
/
8
H1
130
5
1
/
8
L
806
31
3
/
4
L1 620 24
7
/
16
L2
606
2
3
7
/
8
D
206
8
1
/
8
ø
8x8
L1
L2
H1
H
START
STOP
READYFUEL
Planika
HOT
ERROR
N E W S E N S O F F I R E
PAT. PEND.
ECO
D
D
L

Copyright Planika Sp. z o.o. www.planikafires.com i0730#03 02.12.2014 2
C
Near the hinge of the product provide a loose cable of min. 3x0, 75 mm2, with a 230 V, 50 z, which will connect the
device to the mains.
The wall on which the fireplace is hung can be made of any material such as concrete, brick, plasterboard or wood. It
must withstand the weight of the fireplace.
The wall can be covered with any paint, however it is not recommended to wall-papering the walls behind the
fireplace and at the height of up to 1m above the fireplace.
WARNING! The product must be mounted at the level allowing the user to monitor the funnel’s while refuelling.
min 1000 mm
min 39
3
8
"
min 1000 mm
min 39
3
8 "
min 1000 mm
min 39
3
8 "
min 30 mm
min 1
3
16
"
Installation
Fasten the hanging bar "C" to the wall. Use a contour level to accurately level the bar.
1
2

Copyright Planika Sp. z o.o. www.planikafires.com i0730#03 02.12.2014 3
START
STOP
READYFUEL
Planika
HOT
ERROR
N E W S E N S O F F I R E
PAT. PEND.
ECO
C
A
Connection to the mains
must be
made by a qualified electrician
Cable with power supply
D
D
C
3
4
5
F
GG
E E
F

Copyright Planika Sp. z o.o. www.planikafires.com i0730#03 02.12.2014 4
A
B
ATTENTION !!!
• Make sure that the product has been correctly installed and read the attached instruction manual.
• You are not allowed to fill the fuel tank and start the device before having read the instruction manual.
• If in the future it is necessary to take the device out of the housing, wait until the fuel has burned-up
completely and the display shows , disconnect the power supply and take the device out of
the housing.
• Keep this instruction manual throughout the lifetime of the device.
6
FUEL