Playcraft Counter 1615 User manual

IMPORTANT NOTES: Read First
For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
COUNTER ASSEMBLY
Rev A
9/22/2009
1615
Page 1 of 2
NOTE: R3.5 Store Panel shown.
Other panels may vary, but do
not affect the Counter Assembly.
FIGURE 1
Counter Assembly
lubricant during assembly.
(B) Refer to Installation Manual for
Theme Panel assembly instructions.
R3.5-1600, R5-1602 and R5-1602-CAN Panel assembly or corresponding
(A) Use liquid thread lock (such as Loctite
®
) with all threaded hardware. Important: Liquid thread lock (prior to
curing) helps to eliminate the common problem of "thread seizure" in stainless steel hardware by serving as a
See Installation Manual Sections R3.5-
1600, R5-1602 and R5-1602-CAN Panel
Assembly or corresponding Theme Panel

Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
COUNTER ASSEMBLY
Rev A
9/22/2009
1615
Page 2 of 2
HDPE PANEL
COUNTER
3/8" x 5/8"
Barrel Nut
1/2" SAE
Washer
3/8 x 1/2"
Weld Nut
3/8" x 7/8"
O.D. Washer
3/8" x 1" Button
Head Bolt
STORE PANEL
COUNTER BRACKET
3/8" x 7/8"
O.D. Washer
3/8" x 3/4"
Button Head Bolt
FIGURE 2
Parts ListSpecifications
Part # DESCRIPTION QTY.
BE-4285 Store Panel Counter Bracket 3
Varies HDPE Panel Counter 1
9103032-TR Bolt Button Head 3/8" x 3/4" 3
9103052-TR Bolt Button Head 3/8" x 1" 3
9333042 Washer Flat 3/8" x 7/8" O.D. 6
9345002 Washer Flat SAE 1/2" 3
9443022-TR Nut Barrel 3/8" x 5/8" BH 3
9493012 3/8 x 1/2" Weld Nut 3
Step 1
Attach the HDPE Panel Counter to the Panel
as shown in Figure 2. (See Note A)
Step 2
Fully tighten all fasteners according to the
"TIGHTENING TORQUE FOR HARDWARE"
section of the Installation Manual.
HDPE PANEL COUNTER:
Shall be made from high density 3/4" thick hot
extruded polyethylene sheet plastic specially
formulated for optimum UV stability and color
retention.
STORE PANEL COUNTER BRACKET:
Shall be precision laser cut and formed from 3/16"
sheet steel. The Store Panel Counter Bracket has
a multi-stage baked-on powder coat finish.
HARDWARE:
Shall be stainless steel, zinc/nickel plated or
galvanized as required to resist rust and corrosion. Periodically tighten all screws, bolts and nuts. A
periodic inspection of all parts is necessary. If a part
is broken or worn, replace immediately. For general
maintenance please refer to our Playground
Maintenance Manual.
Maintenance