Do not use with: fluorescent lamps, conventional transformers or
low-energy lamps.
Load
Halogen/incandescent (230 V) 0–300 W
LED light source/driver (230 V trailing edge) 0–200 VA
LED light source/driver (230 V leading edge) 0–100 VA
Electronic transformers (12 V halogen) 0–300 VA
Install the product in the appliance box behind the
push button/box lid or secure it with a Mounting clip
(MNT-01, not included) on the wall or DIN rail.
When installing in insulated or warm environments or
with several dimmers in the same box, the total power
is reduced.
DIM-01 is a universal dimmer that can withstand loads
of up to 300 VA and has adjustable minimum, maximum,
and starting levels.
Connect the product
NOTE!
During installation the product is non-dimmable.
Use the app to configure before use.
Control inputs 1 and 2 can be used for control with:
· push button (preset)
· light switch
· motion sensor (with neutral conductor).
The inputs can also be used to wirelessly control one
or more products from Plejd. Additionally, double click
on a push button can be used to activate scenes.
Control inputs 1 2
Support
Follow the instructions in the app
Hand over the Plejd system
Hand over the Plejd system to your customer by
writing the system code on the included sticker .
You will find the code in the app once you have
completed the installation.
Place the sticker in the distribution box and give
the welcome folder HI! to the customer.
In the event of any technical questions,
please contact our customer service:
Download the Plejd app on the App Store or
Google Play.
After supplying power to the unit by following
the wiring diagram, use the app to complete
the installation. Setup requires Bluetooth®and
an internet connection. You do not need any
additional equipment to get started. Use the
app to easily configure all settings.
