Polaroid PLCHUOLY User manual

INSTRUCTIONS
UNIVERSAL CHARGER FOR LI-ION BATTERIES
OLYMPUS
PLCHUOLY
BLM1
BLS1
BLS5
LI20B
LI10B
LI30B
LI40B
LI60B
LI70B
OLYMPUS BATTERY LIST PRECAUTIONARY INFORMATION
Locate your battery type from the list provided. If your type is
not listed, DO NOT USE THIS CHARGER. Improper use can
cause the charging circuit to burn out, and batteries not listed
may over-heat and may combust. Do not use the charger in
wet locations.
CHARGING INSTRUCTIONS
1Insert your choice of power adapter cords into the jack
provided on the rear of the charger, either the 2-prong
120-volt adapter or the 12-volt automotive cigarette
lighter plug.
2The green LED power indicator will light.
3Locate your battery’s model number in figure A and insert
it into that slot. Be sure the battery contacts align with the
charging terminals in the slot.
4The LED will turn red during charging and will return to
green when the charging cycle is complete (30-60 minutes
depending on battery size and voltage rating).
5When the LED returns to green, remove the battery from its
charging slot and disconnect the adapter cord from its
power source.
Questions?
Need some help? For technical support
please call 1-800-226-6534
or visit www.polaroid.com
Distributed by: C&A Licensing, LLC 2 Bergen Turnpike, Ridgefield Park, NJ 07660
Polaroid and Polaroid & Pixel are trademarks of PLR IP Holdings, LLC, used under license. All other
trademarks are the property of the respective owner, who has not sponsored, endorsed or approved this
product. PLR IP Holdings, LLC does not manufacture this product or provide any Manufacturer’s Warranty
or support. For warranty information, visit www.polaroid.com.
© 2011 All Rights Reserved