Pollard 111 User manual

E
S
T
.
1
9
2
1
111 & 141 - Open Leg Bench
Assembly Instructions
www.pollardbros.com
1Stand legs upright and face as shown. Note: 6’
benches and under come with two legs, and 8’
benches and over come with three legs.
Attach stringer to the back leg uprights using (4)
3/8” x 3/4” Hex Head Machine Screws, 3/8“ hex
nuts, and 3/8”washers. HAND TIGHTEN ONLY.
2
#12- 3/4”Wood Screw
3/8” x 2 1/2” Flat Head Machine Screw
3/8” x 3/4” Hex Head
Machine Screw
3/8” Lock Washer
1/4” Hex Nut
1/4” Lock Washer
3/8” Hex Nut
1/4” x 5/8” Round Head
Machine Screw
(2) or (3) Bench Legs (1) Formed Channel Stringer (1) Formed Shelf (1) Formed Back Plate (2) End Plates (1) Hard or MapleTop
Includes:
x
x
x
x
x
xx
2
28
8
26
14
Steps:
x
10
Tools Needed:
wrench at head screwdriver phillips head screwdriver power drill

Pollard Brothers Manufacturing 5504 N. Northwest Highway Chicago IL 60630
. . . .
phone[phone] fax[phone] toll free(800) 551-5566
After top is in place, make sure bench is square and then, tighten all bolts,
starting with the stringer and tie rods.
[2]
3Attach shelf to bench leg crosses with the form
up to the back using (4) 3/8” x 3/4” Hex Head
Machine Screws, 3/8“ hex nuts, and 3/8” wash-
ers. HAND TIGHTEN ONLY.
4Place Bench Top on Bench Legs matching holes
and use (6) 3/8” x 2½” Flat Head Machine Screws
and 3/8” Hex Nuts NO WASHERS NEEDED on
these tops. HAND TIGHTEN ONLY.
5Hold Back Plate with ¾”ange to the back and
even with the bottom of the Wood Top and mark
holes. Suggest drilling pilot holes with #26 drill
(9/64) about 5/8” deep and then assemble back
to Top using (4) #12 ¾”Wood Screws. Note: 3’ to
5’ benches will use (3) and 8’ to 10’ benches will
use (5).
6
Attach End Plates, by rst putting the formed
ange to the back of the Back Plate and fasten
using (2) 1/4” x 5/8” Round Head Machine Screws,
1/4“ Nuts and 1/4” Lock Washers. Next drill pilot
holes on the side and secure using (6) #12 - ¾”
Wood Screws.