Pollard 312 User manual

E
S
T
.
1
9
2
1
312 - Adjustable Height
Steel Shop Stool
Assembly Instructions
www.pollardbros.com
Tools Needed:
wrench at head screwdriver
(1) Stool Seat (1) Stool Frame (4) Leg Extensions
Includes:
1/4” Hex Nut
1/4” Lock Washer
1/4” x 3/4” Round Head
Machine Screw
8x12 x12 x
1Lay seat on a hard surface with under side up.
2
Steps:
Turn stool frame upside down and line up holes
in frame with pilot holes in seat fasten with (4)
¼” x ¾” Hex Head Machine Screws, ¼”Lock
Washer, and ¼” Hex nut.
x
4
1/4” x 3/4” Hex Head
Machine Screw

Pollard Brothers Manufacturing 5504 N. Northwest Highway Chicago IL 60630
. . .
.
phone[phone] fax[phone] toll free(800) 551-5566
After all brackets are in place, make sure table is square and then, tighten all
screws.
[2]
4If Leveler Glides were Purchased, attach Leveler
Glides to Leg Extensions using bolts equiped with
glides like shown.
3Determine the desired height and bolt on the four
adjustable extension legs using (8) 1/4” x 5/8”
Round Head Machine Screws, 1/4”Split Lock
Washers and 1/4” Hex Nuts. Tighten and Turn
Stool Upright.