Pollard 313 User manual

E
S
T
.
1
9
2
1
313 - Adjustable Steel Shop
Stool With Backrest
Assembly Instructions
www.pollardbros.com
1Lay seat on a hard surface with under side up.
Turn stool frame upside down and line up holes
in frame with holes in seatsupports fasten with
(4) ¼” - 20 x ⁄” Hex Head Machine Screws, ¼”
Lock Washer, and ¼” Hex nut.
2
• (1) Steel Stool Seat • (1) Stool Frame • (1)Steel Back Rest • (2) Back Braces • (4) Leg Extensions • (4) Leveler Glides
Includes:
Steps:
¼” Hex Nut
¼” Lock Washer
20 x16 x
x
8
x
4
¼” x ⁄” Round Head
Machine Screw
¼” x ¾” Hex Head
Machine Screw
x
4
Tools Needed:
wrench at head screwdriver
¼” -20 x ⁄” Hex Head
Machine Screw
4x
¼” Hex Cap
x
4
1/4” x ⁄” Carriage Bolt

Pollard Brothers Manufacturing 5504 N. Northwest Highway Chicago IL 60630
. . .
.
phone[phone] fax[phone] toll free(800) 551-5566
After all brackets are in place, make sure stool is square and then, tighten all
screws.
[2]
3
Turn Stool upright. Attach steel stool back to back
braces by inserting (4) ¼” x ¾” Carriage Bolts
through steel back and stool back brace, and fasten
with (4) ¼” Lock Washers, and (4) ¼”Hex Caps.
HAND TIGHTEN ONLY.
Attach Back Braces with Back Rest to Stool Frame
using (4) ¼” x ¾” Hex Head Machine Screws, ¼”Lock
Washers, and ¼”Hex Nuts. HAND TIGHTEN ONLY.
4
5
6Square up Back Rest to Frame if needed. Tighten
Carriage Bolts in Steel Back Rest. The Bolt will t
into the square holes of the back.
Determine the desired height and bolt on the four
adjustable extension legs using (8) ¼” x ⁄” Round
Head Machine Screws. ¼”Split Lock Washers and ¼”
Hex Nuts. Tighten and Turn Stool Upright. Note: If
glides were purchased, you should install them now.