Pollard 506 High Truck User manual

E
S
T
.
1
9
2
1
506 High Truck
Assembly Instructions
www.pollardbros.com
1Place bottom tray down on a at surface lips
down. Note: Bottom Tray will be pierced for
casters. Allign (2) Stationary Casters with holes
on one end of the bottom tray, and attach with
(8) ⁄” x ¾” Hex Head Machine Screws, ⁄”Lock
Washers, and ⁄”Hex Nuts. Repeat with remain-
ing (2) Swivel Casters and (8) ⁄” x ¾” Hex Head
Machine Screws, ⁄”Lock Washers, and ⁄” Hex
Nuts on the opposite end.
3/8” x 3/4” Hex Head
Machine Screw
Turn Tray and Casters over. Attach uprights to
the outside of the tray, matching the four holes
on the upright and tray. Secure with (16) 1/4” x
5/8” Round Head Machine Screws, 1/4”Hex Nuts
and 1/4” Lock Washers. HAND TIGHTEN ONLY.
2
(3) Trays (4) Uprights (2) 5”Polyurethane Stationary Casters (2) 5”Polyurethane Swivel Casters
Includes:
x
x
48
16 x
16 x 16
Steps:
1/4” x 5/8” Round Head
Machine Screw
1/4” Lock Washer 1/4” Hex Nut
x
48
x
48
Tools Needed:
wrench at head screwdriver
3/8” Hex Nut
3/8” Lock Washer

Pollard Brothers Manufacturing 5504 N. Northwest Highway Chicago IL 60630
. . .
.
phone[phone] fax[phone] toll free(800) 551-5566
After all Screws are in place, make sure stand is square, and then tighten all
nuts and bolts
[2]
Attach middle tray to the to the uprights,
matching the four holes on each uprights with
the holes in the tray. Secure with (16) 1/4” x 5/8”
Round Head Machine Screws, 1/4”Hex Nuts and
1/4” Lock Washers. HAND TIGHTEN ONLY.
Attach top tray to the to the uprights, matching
the four holes on each uprights with the holes in
the tray. Secure with (16) 1/4” x 5/8” Round Head
Machine Screws, 1/4”Hex Nuts and 1/4” Lock
Washers. HAND TIGHTEN ONLY.
3
4