Pollard 126 User manual

E
S
T
.
1
9
2
1
126 Steel Top Open Leg Bench
Assembly Instructions
www.pollardbros.com
1Stand legs upright and face as shown. Note: 6’
benches and under come with two legs, and 8’
benches and over come with three legs.
3/8” x 3/4”Hex Head Machine Screw
5/16” Hex Nut
3/8” Lock Washer
5/16” Lock Washer 5/16” x 3/4” Flat Head Machine Screw
3/8” Hex Nut
(2) or (3) Bench Legs (1) Formed Channel Stringer (1) Formed 12ga Steel Top
Includes:
x
x
xx
xx
64
64
6
4
Steps:
Note: (2) additional 3/8” x 3/4” Hex Head Machine Screws & (2) 5/16” x 3/4” Flat Head Machine Screws are provided for 8’ & 10’ benches.
Tools Needed:
wrench at head screwdriver

Pollard Brothers Manufacturing 5504 N. Northwest Highway Chicago IL 60630
. . . .
phone[phone] fax[phone] toll free(800) 551-5566
After top is in place, make sure bench is square and then, tighten all bolts,
starting with the stringer.
[2]
Attach stringer to the back leg uprights using (4)
3/8” x 3/4” Hex Head Machine Screws, 3/8“ hex
nuts, and 3/8”washers. HAND TIGHTEN ONLY.
2
3Slide Top with back plate onto legs starting at
either end matching holes in Bench Leg top.
Use (6) 5/16” x ¾” Flat Head Machine Screws
with 5/16” Hex Nuts and Lock Washers. HAND
TIGHTEN ONLY.