Pollard 301 User manual

E
S
T
.
1
9
2
1
301 - Shop Stool With Backrest
Assembly Instructions
www.pollardbros.com
1Lay seat on a hard surface with under side up.
Turn stool frame upside down and line up holes
in frame with pilot holes in seat fasten with (4)
#12 x ¾” wood screws.
2
(1) Stool Seat (1) Stool Frame (1)Wood Back Rest (2) Back Braces
Includes:
x
4
Steps:
#12- 3/4”
Wood Screw
1/4” Hex Nut
1/4” Lock Washer
4x4x4x
1/4” Hex Cap
1/4” x 1” Carriage Bolt
x
4
x
4
1/4” x 3/4” Hex Head
Machine Screw
Tools Needed:
wrench at head screwdriver phillips head screwdriver

Pollard Brothers Manufacturing 5504 N. Northwest Highway Chicago IL 60630
. . .
.
phone[phone] fax[phone] toll free(800) 551-5566
After all brackets are in place, make sure stool is square and then, tighten all
screws.
[2]
3Turn Stool upright. Attach wood stool back to
back braces by inserting (4) 1/4” x 1” Carriage
Bolts through wood back and stool back brace,
and fasten with (4) 1/4” Hex Caps. HAND
TIGHTEN ONLY.
Attach Back Braces with Back Rest to Stool Frame
using (4) 1/4” x 3/4” Hex Head Machine Screws,
1/4” Lock Washers, and 1/4” Hex Nuts. HAND
TIGHTEN ONLY.
4
5Square up Back Rest to Frame if needed. Tighten
Carriage Bolts in wood Back Rest. The Bolt will
indent (set itself) into the wood back.