Take all the components apart and rinse
them in running water. If the filter sponge
has any tears, replace it. Filters are available
by the authorized Polti Service Centre.
A cleaning brush (20-A) is supplied for easy
cleaning of the water container (20); use it
also to clean the appliance’s hose connec-
tions and the inside of tools.
NOTE: Do not use the brush for cleaning the
outside of the appliance
If you wish to continue working, top up the
level of the water. Put the “EcoActiveFilter”
water filter assembly (23) back into the water
container (20).
ATTENTION: line up the arrow on the elbow
tube (27) with the mark on the net filter hous-
ing (26) (Fig.11b). Put the water container
(20) back in place as described in the
“preparation for use” section.
NOTE: make sure you empty the water con-
tainer (20) before putting your Vaporetto
away. One of the great advantages of Va-
poretto is precisely the fact that it is possible
to put it away clean.
TT
TTII
IIPP
PPFF
FFOO
OORR
RR
UU
UUSS
SSII
IINN
NNGG
GG
TT
TTHH
HHEE
EEAA
AACC
CCCC
CCEE
EESS
SSSS
SSOO
OORR
RRII
IIEE
EESS
SS
DO NOT USE STEAM FUNCTION ON
DRAYLON, VELVET, LEATHER OR
OTHER SENSITIVE SURFACES.
If in doubt about the effect of steam on other
surfaces, consult the manufacturer’s instruc-
tions and always proceed only after carrying
out a test on a hidden part or a sample. Al-
low the area treated with steam to dry and
then check whether any changes in colour or
deformations have occurred before proceed-
ing further, ensuring exactly the same steam
power and distance as in the test.
When cleaning wooden surfaces (furniture,
doors, etc.) and brick floors always proceed
with caution since excessive use of steam
could damage the wax, the polish or the
colour of the surface to be cleaned. It is
therefore advisable to apply the steam to
these surfaces only for short periods at a
time or, instead to clean them with a cloth
that has been treated with steam.
On particularly delicate surfaces (e.g. syn-
thetic materials, enamelled surfaces, etc.)
we strongly recommend using the steam at
its lowest output power.
When cleaning glazed surfaces, if the
weather is particularly cold pre-heat the
glass working at distance of about 50 cm
away from the surface. To take care of your
plants, we recommend spraying them from a
distance of at least 50 cm.
UU
UUNN
NNII
IIVV
VVEE
EERR
RRSS
SSAA
AALL
LLBB
BBRR
RRUU
UUSS
SSHH
HH((
((EE
EE))
))
Use this brush to clean large surfaces, tiled
or marble covered floors, parquet, carpets
etc., using the following inserts supplied with
it:
• Bristle inserts (E2), for use when vacuum-
ing only.
• Liquid suction inserts (E3), to pick up liq-
uids; recommended for smooth surfaces.
• Fitted carpet inserts (E4), suitable for fitted
and loose carpets.
The universal brush can be connected di-
rectly to the handle, or to the hose by means
of the extension tubes (D).
ASSEMBLING INSERTS:
to change the inserts, slide in the insert from
its position on the brush and slide in the re-
placement (Fig.C). When assembling the
two inserts with bristles (E2), position the
solid insert towards the BACK of the brush
and the grooved insert towards the front.
When assembling the inserts for suctioning
up liquids (E3), take care to ensure that their
SMOOTH side faces inward.
11
1122
2200
00°°
°°
SS
SSTT
TTEE
EEAA
AAMM
MM--
--SS
SSUU
UUCC
CCTT
TTII
IIOO
OONN
NN
AA
AACC
CCCC
CCEE
EESS
SSSS
SSOO
OORR
RRYY
YY
((
((KK
KK))
))
Use this accessory to clean areas that are
difficult to reach with other accessories. The
120° accessory may be used for:
• treating stains on carpeting or loose car-
pets, before going over them with the
brush;
• cleaning stainless steel, windows, mirrors,
layered coating and paintwork;
• cleaning corners such as stairs, windows
frames, door jambs, aluminium sections;
VAPORETTO ASPIROVAPOR
50