
Read before assembling the structure
Warning
This structure is intended to be self-supporting once constructed with all frames, hardware,
sheathing, sheeting, bracing, cables, and membrane in place and secured to the foundation as
shown in the manual. Stability during construction, from winds and loads imposed during
erection, is the sole responsibility of the installer. Observe safety codes required by your
jurisdiction, and relevant safety practices for working at heights. Avoid the risk of electrical shock
from overhead lines or electrical storms. Poly-Tex recommends contracting a licensed electrician
to perform electrical work. Eye protection is recommended under all circumstances and hearing
protection is recommended when cutting components with power tools.
Danger: No part of this structure is engineered to function as an anchorage point for a fall
arrest system. Use a safety net or work from a safe work platform (i.e. scaffolding).
Overview of assembly procedure
While each structure and site is unique, and may require special considerations, these
instructions are for a tilt-up method (where frames are assembled on the ground and tilted
onto ground stakes or anchor rods using ropes or lifts). If you do not feel confident installing
the structure, Poly-Tex suggests you hire a general contractor, carpenter, or similar licensed
business familiar with construction to assemble, install and erect your structure.
Foundations
These instructions include minimum guidance for foundations based on the International
Building Code. These minimums are suitable for some areas of the country but not all. Obtain a
building permit if required in your jurisdiction. Engineered Certified foundation plans may be
required by a building official before issuing a permit. Even if not required, seeking guidance
from a qualified structural or civil engineer for the foundation design will prove worthwhile over
the life of your structure. A flawed foundation may only become obvious after your structure has
been damaged. Replacing a deficient foundation is expensive and inconvenient.
Warning: Do not walk on polycarbonate sheets. Always use scaffolding to avoid damage
to sheeting and to ensure safety. Polycarbonate sheeting has UV coating protected with vinyl
film on the exterior surface. Install sheets with the film intact and toward the exterior. Remove
film once the sheet has been fastened in place.
Danger: Select a calm day for work. Wind can be sufficient enough to knock you off a work
platform or ladder, resulting in a potentially deadly fall.
REV: AD 231117
*Wiggle Wire is a Registered Trade Mark of Poly-Tex, Inc