Polycom SoundPoint IP 670 User manual

Telephone User
Guide
Polycom IP 670/ IP 560/ IP 330

New phone user
Name: ______________________
Your new phone has its own direct phone number ______________.
Your extension is _______.
To begin using your phone, please follow these steps to setup your Voicemail.
1. Pick up the handset.
2. Press the MSG Key or *97 if no MSG Key.
3. Enter the default password. (ext number)
4. Press 0.
5. Press 5 and then follow the prompts to change your password.
6. Press 1 and then follow the prompts to record your Unavailable Message.
Example: (You’ve reached “Name” I’m away from my desk. Please leave a message and
I will get back to you as soon as I can. Thank You.)
7. Press 2 and then follow the prompts to record your Busy Message.
Example: (You’ve reached Name, I’m on the phone. Please leave a message and I will
get back to you as soon as I can. Thank You.
8. Press 3 and then follow the prompts to record your Name.
Example: (Name)
If you have any problems or questions please contact your system administrator.

Keypad
The numeric keypad with the keys 0 to 9, *, and # is used to enter digits and letters.
Depending on the operating mode, different actions can be performed (see the table
below):
Entry of digits only (e.g., when dialing a phone number)
Typing in letters and digits by pressing the keys repeatedly (similar to a cellular phone),
etc.
Dialing
There are two methods to begin a call from the idle state of the phone. You can either dial
with the handset resting in the cradle and then pick it up or press speaker and then dial the
number. The phone shows the current communication status in the display.
Accepting a call
Picking up the handset or pressing speaker will accept the call. The phone is now in a
call. Pressing MUTE/DEL while the phone is ringing will send the call to your
voicemail.
Terminating a call
End calls by placing the handset on its cradle or pressing speaker. The phone will
terminate the call and return to the idle state.
Adjusting the volume
In the idle state or while making a call, you can use the arrow keys to increase or lower
the volume. The audio device (speaker, handset, headset) that you are currently using can
be adjusted.
Mute / Un-mute
To mute the microphone during a call, press the Mute key, Un-mute to enable the
microphone again.
Handset / Hands-free / Headset
The phone supports calls made using the handset or hands-free capability. During a call,
it is possible to switch between both modes by pressing the Speaker key.
When a headset is connected, the phone will treat the headset as the output device for
calls. The speaker key is therefore used to accept and terminate calls.
Park & Retrieve
To Park a call is to put it on hold in a place anyone could retrieve. While in a call press
the ## key an dial 70#. Wait for the system to tell you which extension the call is parked
on (71, 72).
To retrieve a parked call, dial the number where the call is parked. (71-79) Press the send
button and you will be connected to the parked call.
Hold and Resume
When a call is in progress, pressing hold button puts the call on hold, i.e., neither party
can hear the other.
Pressing the line key will resume the call. While a call is on hold, you can establish
another call by dialing the desired number.

Direct Transfer
During a call, press the transfer key to put the connected party on hold, then dial the
number to which the call is to be directly transferred. Then press Send.
Transfer to Voicemail
To send a call to another person’s voicemail, press the transfer key, dial * and the
person’s extension number then send. The phone will transfer the held party to that
voicemail.
Conference 3 Way
(For your extension and two other calls)
If the phone is connected with two calls, one on hold and one active, you can connect all
three phones in a conference by pressing CONF. By pressing again, the conference is
disconnected and the calls are all put on hold.
For more than 3 parties
While in a call press the Transfer button , then dial 8001 and then press to transfer that
call into a conference room. Do this for each caller to be added to the conference call. To
join the conference call from an office phone just dial 8001 to join the call in progress. If
there is only one caller in the conference room music will be played until another caller
joins.
Message Waiting Indication (MWI)
If you did not answer a call and the mailbox recorded a message for you, the Message
Light will be flashing.
Call History
Maintains lists of calls that can be accessed by pressing the round key and selecting call
history from the idle state.
For example, after choosing the missed calls, the most recent missed call is displayed
first.
By pressing the down arrow key, you can get details about this missed call: To, From,
Time, and Missed.
DND Mode on/off
DND is short for Do Not Disturb. If this mode is activated incoming calls will no longer
come through to the phone and you will be completely undisturbed by the phone. If there
is a mailbox set up for you, the call is redirected to voicemail.
To enable Do Not Disturb dial *78.
To disable Do Not Disturb dial *79.
Call Forwarding unconditional
To enable Call Forwarding dial *72#
Enter your extension and press #.
Enter the phone number or extension number to forward all calls to then press #.
To disable Call Forwarding dial *73
Call Forwarding-Busy
To enable Call Forwarding-busy dial *90#
Enter your extension and press #.
Enter the phone number or extension number to forward all calls to then press #.
To disable call forwarding-busy, dial *91#.

Feature Codes
Feature Code Action
*30 Blacklist a number
*31 Remove a number from the blacklist
*32 Blacklist the last caller
*52 Call Forward No Answer/Unavailable Activate
*53 Call Forward No Answer/Unavailable Deactivate
*69 Last Called ID
*72 Call Forward All Activate
*73 Call Forward All Deactivate
*74 Call Forward All Prompting Deactivate
*90 Call Forward Busy Activate
*91 Call Forward Busy Deactivate
*92 Call Forward Busy Prompting Deactivate
*70 Call Waiting - Activate
*71 Call Waiting - Deactivate
*28 Day/Night Control Toggle
*34 Perform dictation
*35 Email completed dictation
*78 DND Activate
*79 DND Deactivate
1 Voice Intercom prefix
*0 Speed dial prefix
*75 Set user speed dial
*97 My Voicemail
*98 Dial Voicemail
## + xxx+# To Transfer a Call
##70# Park Call
71=79 Pickup Parked Call
**xxx Directed call pickup (** + the extension to be picked up)
*xxx Call directly to an extension’s voicemail

Setting Up Voice Mail
Recording unavailable, busy or temporary greetings
To access your mailbox press MSG
Enter pass-code ________
Press [0]
Press [1] Unavailable, [2] Busy or [4] Temporary
Record your greeting
Press # to end the recording
After recording a message (incoming message, greeting, or name)
[1] Accept
[2] Review
[3] Re-record
[0] Reach operator
Voicemail User Menu and Options
[1] Play voicemail messages
[2] Change folders
[*] Help
[#] Exit
[0] Mailbox options
[1] Record your unavailable message
[2] Record your busy message
[3] Record your name
[4] Record your temporary message
[5] Change your password
[*] Return to the main menu
Voicemail Message Playback Menu
[3] Advanced options
[1] Reply
[2] Return call to number that left message
[3] Envelope
[4] Play previous message
[5] Repeat current message
[6] Next message
[7] Delete current message
[8] Forward messages to another mailbox
[9] Save message in a folder
[*] Rewind during message playback
[#] Skip forward during message playback
Accessing Voicemail from out of the office
Call your direct line and wait for your voicemail message to start and then press the * key
then enter your password.

Managing your phone from your computer
Enter the web address supplied by your system administrator
http://______________________
Login
Login: Your extension number
Password: Your voice mail password
Submit
Remember Password
Use your Voicemail Mailbox and Password
This is the same password used for the phone
For password maintenance or assistance, contact your Phone System Administrator.

Manage your voicemails on line
Voicemail for Chris Martin (251)
Results 1
select: all none
Date Time Caller ID Priority Orig Mailbox Duration Message
2007-01-20 18:12:42 "John Doe" 3 251 4 sec play

Change Your Settings
Call Routing
Call Forwarding:
Enable
Voicemail
Settings
Voicemail Password: ***
Enter again to confirm: ***
Passwords must be all numbers and at least 3 digits
Email Voicemail To: [e-mail]
Pager Voicemail To:
Enable
Email voicemail as attachment
Say caller id in recording emailed
Say envelop (date/time) in recording emailed
Delete voicemail when emailed
Audio Format: Smallest Download (.gsm)
Call Monitor
Settings
Record INCOMING: Always Never On-Demand
Record OUTGOING: Always Never On-Demand
Update