PotteryBarn Marble and Metal Floor Storage User manual

Marble and Metal Floor Storage
1/2
●Please read all instructions carefully and completely before beginning assembly.
●Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
●Use the parts and hardware lists to identify and separate each of the components included.
●For your safety and ease, assembly by two people is recommended.
Hardware Included:
A. 4mm Allen Key (1pc) B. M5x10mm Bolt (24pcs) C. Ø10mm Metal Washer (24pcs)
Parts Included:
D. Left & Right side frame (1pc each) E. Center Rail (6pcs) F. Marble Shelf with pre-attached metal pins (3pcs)
Assembly Instructions:
1. Carefully remove all parts and hardware from packaging and lay out on a clear work surface.
2. Connect both frames to the center rails by inserting the short steel tube which is pre-attached to the frame into the center rail.

Marble and Metal Floor Storage
2/2
3. Secure the center rails to the frame using the bolts (B) and metal washers (C). Tighten with the enclosed Allen key (A).
4. Place marble shelves (with metal pin side down) by holding at a slightly tilted angle and inserting onto frame.
5. Levelers are pre-installed on the feet. Adjust as needed to make sure floor storage is level. Turn counter-clockwise to
increase height, clockwise to decrease height. Assembly is complete.
Care instructions:
●Dust with a clean, soft damp cloth. Wipe dry immediately. Avoid the use of chemicals and harsh cleaning agents.
thank you for your purchase
stores/catalog/www.potterybarn.com