PotteryBarn Cynthia Wardrobe User manual

Cynthia Wardrobe
Pre-Assembly:
• Please read all instructions carefully before beginning assembly
• Save all packing materials until the wardrobe is fully assembled to avoid accidentally discarding any small
parts or hardware
• Use the parts and hardware lists to identify and separate each of the components included
Parts Included: Hardware Enclose:
(2) Shelf - A (1) Hanging Rod - B (8) Shelf Pin - C (2) Extra Glass Knob
with Nut
Assembly Instructions:
1. Determine the desired height for the shelves (A) using the pre-drilled holes located within the wardrobe as a guide.
Insert the shelf pins (C) into the pre-drilled holes on two sides of the wardrobe until fully inserted. Carefully place the
shelves (A) onto the shelf pins (C). Make sure each shelf has 4 shelf pins supporting it from below.
2. Place the hanging rod (B) onto the two pre-attached wood blocks located on the side panels of wardrobe.
3. Assembly is complete.
A
C
B

* Note: There are (2) extra glass knobs for this wardrobe. Follow the below instructions to replace the wooden knobs:
A. Remove wooden knobs: Hold the wooden knob. Unscrew by turning counter-clockwise. Keep knob for future use.
B. Attach the glass knob: Hold the glass knob against front of door and drawer. Align with pre-drilled screw hole. Insert
the nut from outside. Screw from inside into the knob as shown. Tighten with screwdriver, turning clockwise.
Note: Glass knob is fragile. Use caution while attaching or detaching.
Care Instructions:
• For daily cleaning, wipe with a soft damp cloth; Wipe dry immediately.
• To protect the finish, avoid the use of chemicals and harsh cleaning agents.
thank you for your purchase
stores | catalog | www.potterybarn.com