Prem-I-Air PEVAPKY32 User manual

Important Safety Instructions
Specifications
Product Description
Operating instructions
Additional use notes
Service & Warranty
1
2
3
4-5
6-9
10
11-13
14-15
16
17
18
19
20
21-22
23
24
25
Bs plug wiring
Operating Methods
Installation guide for castors, drainage pipe and air exhaust accessories

-1-

please ensure it is kept 50cm away from walls, curtains or
other objects, at the front and back of the unit.
rating plate
-2-

-3-

PRODUCT DESCRIPTION
-4-

ACCESSORIES FOR HEAT EXHAUST HOSE
ACCESSORIES FOR DRAINAGE
-5-

The castors must be installed you
under the
This will require 2 people.
Lift up
Installation method
Note:
Install the drainage hose before operating the unit.
Remove the drainage cap and store for future use.
1) Take out drainage cap from drainage point at the back of the unit.
A.Drain point
B.Drain cap
2) Install drainage cap on the end of the drain hose drainage hose.
3) Fix the fixing clip for drainage hose at rear plate using the bolt.
A.Drain point
B.Attach drain hose clip with bolt provided.
4)Insert one end of drainage hose into the drainage point and assemble hose clip to prevent water
leakage.
5)Fix drainage hose with the fixing clip.
-6-

All refrigeration A/C units (portable or fixed) make condensate water (condensation) during their
cooling cycle.
To remove this water, this unit has a self evaporating function. This feature allows the unit to
collect condensation in a tray, then hot air (exhaust air) is passed over the water and it evaporates, it
is then discharged outside as humid air through the exhaust hose.
A safety feature is included on this collection tray for any excess water. If the reservoir is full, the
compressor and motor will stop. The buzzer will sound 8 times and the LCD display will show E4.
The unit will stop operating until the water tray is emptied and compressor has rested for at least 3
mins.
Take out the hose from the fixing clip and remove the cap from the drainage hose. The water will
them empty. Use a suitable container to collect the water and empty down your sink or toilet. After
drainage put the cap on the end of the hose to prevent any water leakage and fix hose back on
fixing clip.
The air conditioner will work again once this excess water has been removed.
Also at the end of the season and or before moving the unit, it is advisable to drain down whether
the tray is full or not, by draining the water from the "bottom" drain, follow the instructions below
To operate the air conditioner with a continuous drain, connect the drain hose provided to the drain
outlet and run to a water container. Remove the drain cap. Retain for future use. The hose but must
run downhill from the unit as the water is discharged by gravity only.
Permanent Drain Option
DRAINAGE METHOD
-7-

out of
The
hoses as it can
unit to not operate inefficiently.
not be below the exhaust hose hole on the back of
the unit.
Eg.
-8-

DO NOT
BEND AS
BELOW
If is bent in too many places, it could easily malfunction
bending
-9-

do not operate the unit.
please take to a qualified engineer for repair.
30
30
-10-

-11-

to be
can set the timer to run
the unit for a specified lengh of time and once reached You can set the time
between
press it again and
-12-

. Leave
to create good ventilation.
to effectively cool,
close
It
and the unit will
is efficient constant
(HEAT on selected models only)
or window
Keep
there
S
-13-

A
-14-

speeds in
you
left.
If there is a ppcue cut to the unit
you
uma pave cut and on restun a close not cpevate corrctly,
please switch off and
In sleep mode please note that you
can only set timer for 1-7 hours
-15-

starts to run
the
the and
will
and
-16-

If in dehumidification mode, fan will run in 10W
speed.
-17-

pressed
-18-