Prem-I-Air KY32 User manual

(Cooling only)
(Cooling & Heating)

Important Safety Instructions
Specifications
Product Description
Operating instructions
Additional use notes
Service & Warranty
1
2-3
4
5-6
7-11
12
13-23
24-25
26
27
28
Bs plug wiring
Operating Methods
Installation guide for castors, drainage pipe and air exhaust accessories

B
BS SP Pl lu ug gW Wi ir ri in ng g
Wiring Instructions: Should it be necessary to change the plug
please note the wires in the mains lead are coloured in accordance
with the following code:
BLUE - NEUTRAL
BROWN - LIVE
GREEN AND YELLOW - EARTH
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
1. The BLUE wire is the NEUTRAL and must be connected to the
terminal which is marked with the letter Nor coloured BLACK.
2. The BROWN wire is the LIVE and must be connected to the terminal
which is marked with the letter Lor coloured RED.
3. The GREEN/YELLOW is the EARTH and must be connected to the
terminal which is marked with the letter Eor or coloured GREEN
OR GREEN/YELLOW.
4. Always ensure that the cord grip is positioned and fastened correctly.
If a 13A (BS 1363) fused plug is used it must be fitted with a 13A fuse. If
in doubt consult a qualified electrician.
Wiring for a 13 Amp Plug (BS1363)
Please note. The Earth Terminal is marked with the letter Eor Earth
Symbol .
-
1
-

2
2

KY-32
3

I
IM MP PO OR RT TA AN NT TS SA AF FE ET TY YI IN NS ST TR RU UC CT TI IO ON NS S
Read and save these important safety instructions before using this unit. When using electrical
appliances, basic safety precautions should always be followed including the following:
1. Transport & store the unit in an upright position only. Leave it in an upright
position for at least 3 hours before first use.
2. Always place the unit on an even, level surface.
3. An opening in a window or wall is required to accommodate the exhaust hose to
expel the hot air.
4. Make sure the unit is connected to an earthed power supply of the correct rating.
(Refer to the rating label located at the back of the unit).
5. The unit will cool when the room temperature is between 18°C~32°C depending
on the thermostat setting.
6. Operate this unit in an ambient temperature of 32°C or lower.
7. DO NOT use this unit for functions other than those described in this instruction
manual.
8. DO NOT tilt the unit.
9. DO NOT cover or obstruct the appliance’s inlet and outlet grilles.
10. Your air conditioner has been designed to be used only in the home, office and
similar conditions and should not be used for any other purpose.
11. Never unplug the air conditioner while it is working, this could damage the
electronic circuits.
12. DO NOT use the appliance in a wet room, such as a bathroom or laundry room to
avoid the risk of electrical shocks.
13. Do not bend or crush the warm air exhaust hose.
14. DO NOT sit or place articles on the appliance.
15. DO NOT use the appliance with wet or damp hands.
16. DO NOT let chemical substances come into contact with the appliance.
17. DO NOT use the appliance in the presence of flammable substances or vapours
such as alcohol, insecticides, petrol, etc.
18. DO NOT use the plug to start and stop the appliance. ALWAYS use the control
panel to start and stop the unit.
19. ALWAYS keep an air path of at least 50cm from walls, furniture or curtains.
20. ALWAYS turn off the appliance when it is not in use and remove the mains plug
from the socket outlet.
21. ALWAYS turn the unit off and remove the mains plug before cleaning, carrying
out maintenance or moving location.
22. Avoid the use of adapter plugs, multiple sockets and /or extension leads. If their
use is necessary, ensure they conform to current safety standards.
23. Do not pull the electrical cable or place it near a source of heat: always unroll it
completely to avoid dangerous overheating. If the supply cord becomes
damaged, the service agent or a similarly qualified person must replace it, in
order to avoid a hazard.
24. The filter must be used with the product at all times, when removing it for clearing
always turn the unit off and unplug the mains plug from the socket.
25. Do not operate the fan with a damaged power cord or plug, after it malfunctions,
has been dropped or damaged. If the power cord is damaged it must be replaced
by the manufacturer or a qualified service engineer to avoid a hazard.
For those who are not aware of the danger that might occur from the usage of an electrical
appliance, they should use the product under guidance and supervision.
THE MANUFACTURER DISCLAIMS ANY RESPONSIBILITY, IF THE ABOVE
INSTRUCTIONS ARE NOT FOLLOWED.
- 3 -

PRODUCT DESCRIPTION
-5-

$&&(6625,(6 )25 +($7 (;+$867 +26(

5(027(&21752/
,03257$17)2586(:,7+5(027(&21752/
3OHDVHREVHUYHFRUUHFWEDWWHU\SRODULW\PDUNLQJVLQWKH
EDWWHU\FRPSDUWPHQWWRHQVXUHWKDWWKH\DUHLQVHUWHG
FRUUHFWO\
7KHUHPRWHFRQWUROLVGHVLJQHGQRWIRUXVHZLWKUHFKDUJH
DEOHEDWWHULHV
5HPRYHEDWWHULHVIURPUHPRWHFRQWUROZKHQQRWXVHGIRU
ORQJSHULRGRIWLPH
7KHEDWWHULHVFRQWDLQPDWHULDOVZKLFKDUHKD]DUGRXVWR
WKHHQYLURQPHQWWKH\PXVWEHUHPRYHGIURPWKHDSSOLDQFH
EHIRUHLWLVVFUDSSHGGLVSRVHRIWKHEDWWHULHVUHVSRQVLEO\
1RWHG[$$EDWWHULHVLQFOXGHV

The castors must be installed you
under the
This will require 2 people.
Lift up
-7-

-8-
Step1
Follow the steps below
into position
condensate

DRAINAGE METHOD
-9-
1) Pull out plug and push the nozzle downwards.
2) Connect a suitable hose to the nozzle.
3) Make sure that the hose is not kinked.
4) Only use this feature when permanent drainage is
required. Keep the nozzle in its closed position
when not in use to avoid leaks.
Take care to avoid water spillage when disconnecting
the drain plug.
Continuous Continuous

out of
The
hoses as it can
unit to not operate inefficiently.
not be below the exhaust hose hole on the back of
the unit.
Eg.
-10-

DO NOT
BEND AS
BELOW
If is bent in too many places, it could easily malfunction
bending
-11-


.<'0RGHO


to be
can set the timer to run
the unit for a specified lengh of time and once reached You can set the time
between
press it again and
-14-
HEATING
HEATING
and

. Leave
to create good ventilation.
to effectively cool,
close
It
and the unit will
is efficient constant
(HEAT on selected models only)
or window
Keep
there
S
-15-
stop operating