Prem-I-Air EH1712 User manual

1
EH1712, EH1714, EH1716, EH1718
TUBULAR HEATER

2
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product for
future reference. PRODUCT DEFINITIONS
EH1712 –45W Tubular Heater EH1714 –80W Tubular Heater
EH1716 –135W Tubular Heater EH1718 –180W Tubular Heater
BEFORE USE
You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately. PRODUCT SAFETY
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
Do not cover.
For indoor use only.
Do not use in bathrooms,
Do not use in wet or damp locations.
Do not place the mains lead beneath a carpet or rug.
Do not use the heater in locations where paint, petrol or other flammable liquids
are used or stored.
Please ensure heater is switched off when not in use, also unplug before
assembly or disassembling parts.
Please avoid the use of an extension lead with this heater as this could cause
the product to overheat.
Do not use the heater for other than its intended use.
WARNING –The surface of this electrically heated tubular heater can be very
warm; in order to avoid overheating do not cover the heater.
Precautions should be taken to ensure direct contact with the heater does not
occur, this includes but is not limited to ensuring children are not left
unsupervised in the vicinity of the heater.
If this heater is to be used in a public place, suitable warning signage should
be used in order to ensure people’s safety.
This tubular heater is designed for wall-mounting only and is not to be used
in any other way.

3
INSTALLATION
It is very important that the tubular heater is mounted horizontally to a wall at low-
level. Do not mount below a socket outlet. Any shelving above the heater must be
at a distance of no less than 200mm. Air should be allowed to circulate freely
around the heater in order to prevent overheating.
THE TUBULAR HEATER MUST NOT BE COVERED.
The fixing brackets should be mounted accordingly to the heater length at a
distance to adequately support the Heater.
Screw the two bottom halves of the brackets to the wall. Place the Tubular Heater
on the brackets. Fasten the top brackets over the tube. DO NOT SWITCH ON
THE HEATER UNTIL AFTER IT HAS BEEN SECURED.
PAT TESTING
When used in a workplace, this product should be safety-tested yearly by a
qualified electrician (PAT Tested). We recommend that it is PAT tested regularly
when used in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory for
new buildings).
ELECTRICAL
The electrical installation of this Tubular Heater must be carried out bya competent
electrician and be in accordance with the current I.E.E. Regulations for Electrical
Equipment in Buildings. The Tubular Heater is suitable for operation on a 50Hz AC
supply voltage as shown on the identity label. Before connecting the heater check
that the supply voltage is the same as stated on the identity label. DO NOT
DIRECTLY EXPOSE TO WATER
THIS DEVICE IS NON-USER SERVICEABLE
Should difficulty be experienced with this heater, consult a qualified electrician.
MAINTENANCE
Before cleaning, turn the heater off, and disconnect from the mains supply. The
heater may then be cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do no use stronger detergents or solvents
as these may damage the plastic.

4
Using a dry 1" (25 mm) paint-brush, remove any dust from the tube.
If the mains lead is damaged, it must be replaced by the manufacturer or an
authorised service centre. If the mains plug needs to be replaced, proceed as
follows:
Connect the brown wire to the terminal
labelled "L".
Connect the blue wire to the terminal
labelled "N"
Connect the green/yellow wire to the
terminal labelled with the earth symbol or
"E".
Make sure that the cord-grip is
positioned correctly (over the outer sheath of the cable) and it fully tightened.
SAFETY
Due to the high surface temperature of these heaters, we strongly recommend
the use of our safety guards whenever the devices are situated below 2m from
the floor or where Animals, Children or Flammable objects (such as clothing) may
come into contact with the heater. These are available from your stockist.
Product Codes:
EH1720 –Protective Grille
EH1722 –Replacement Brackets

5
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and disposal
is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your retailer may
take the old appliance for disposal.
SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in materials and workmanship
for a period of one year.
Should this unit be operated under conditions other than those recommended, at
voltages other than the voltage indicated on the unit, or any attempts made to
service or modify the unit, then the warranty will be rendered void.
The product you buy may sometimes differ slightly from illustrations. This warranty
is in addition to, and does not affect, your statutory rights.
If you have any problems with this product, please call our Help Desk on (0845)
459 4816.
Prem-i-Air Appliances Ltd.,
Lancots Lane,
Sutton,
St. Helens,
Merseyside.
WA9 3EX
Website: www.prem-i-air.co.uk