Primera LX2000 Use and care manual


LX2000/LX1000VacuumTubeMaintenanceKitandInkPadReplacement
TheLX2000hasavacuumsystemtocarryexcessinkoversprayintotheinksaturationpads.Depending
onhowoftentheprinterisused,someinkcanbuildupinsidethetubeopeningandeventuallyblockthe
vacuumtubeopening.InkPadscanalsobecomesaturatedovertimeandshouldbereplaced.
TubeCleaningMaintenanceInterval:Performthismaintenanceevery10,000printsoratthefirstsign
ofanyinkbuildupontheinternalmechanism.Ifyoustarttoseeamagentafogonanyoftheinternal
components,thismaintenanceshouldbedoneregardlessofhowmanyprintshavebeensenttothe
printer.
InkPadMaintenanceInterval:50,000prints
MaintenanceKitPartNumber:661380–Purchaseonwww.primera.com
Kitincludes:Inkpadtraywith2xsaturationpads,1xcleartubetocleanthevacuumtubeopening.
1. OpentheCover

2. LocatetheblackInkcapturebin.

3. Liftthelatch(1)andpullthecoverforward(2).






4. Lookforthetubeopeningbehindthesmallplasticbarrier.Youmayneedtouseaflashlightto
seetheopening.







5. Locatethecleartubeincludedwiththekit.Thetubeisjustsmallenoughtofitinsidethe
vacuumtube.Insertthetubeintothevacuumtubeopening.Tip!Userubberglovesforthis
part.













6. Pushthetubeasfarasyoucanwhilestillholdingitwithyourfingers.


7. Removethetube.Itshouldbefullofblack
ink.Onecleaningisusuallyenough.
However,youmaywashthetubeandrepeat
thecleaningimmediately,savethetubefor
repeatuseordiscarditafteruse.

8. ReplacetheInkCaptureBinCover.

9. Finallyreplacetheinkpadsaturationtrayby
pushingdownonthereleasepinandpulling
thedrawerout.

Note:Thenewtrayhasonly2saturationpads
insteadof3.Thiswasdonetoprevent
blockageofdrainholesinsidethecapturebin.