Pro-Elec PELL0008 User manual

4 LED MOTION SENSOR LIGHT
PELL0008
Please read these instructions carefully before use and retain for future reference.
• Avoid locations of high temperature or humidity.
• For indoor use only.
• If the light output becomes less bright or ashes, replace the batteries.
• Always remove the batteries if the light is not to be used for long periods.
• Never mix new and old batteries or mix different battery types.
• Remove the rear cover and insert the batteries noting the correct polarity.
• Replace the cover and slide the switch to either on or auto position.
• Drill a hole in the wall where required with regard to any concealed wiring or pipework.
Fit a wall plug if required and screw in a
dome head screw leaving the head 4mm
proud of the surface.
• Locate the keyhole slot in the rear of the
light unit over the screw
head and ensure the light
is securely xed.
IMPORTANT SAFETY INFORMATION
INSTALLATION
Keyhole slot
Switch
Batteries

OPERATION
MAINTENANCE
SPECIFICATION
• In AUTO mode the motion sensor will turn on the light when movement is detected
only in low light environments.
• After motion ceases to be detected, the light will
extinguish after 25 seconds.
• When in the ON mode the light will remain
permanently lit.
• Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
Power supply: 3×AA batteries (NOT included)
Material: ABS, PS
Light Source: 4 × F5 LED
Output power: 26 lumen
Ambient light: <10LUX
Sensor distance: 0-5m
Sensor angle: 120°
Time delay: 25±2 sec (Auto-delay function)
Product weight: 73g
Product size H x W x D: 120×70×40mm
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0