Pro-Elec PELL0009 User manual

3 LED MOTION SENSOR LIGHT
PELL0009
Please read these instructions carefully before use and retain for future reference.
• Avoid locations of high temperature or humidity.
• For indoor use only.
• If the light output becomes less bright or ashes, replace the batteries.
• Always remove the batteries if the light is not to be used for long periods.
• Never mix new and old batteries or mix different battery types.
• Remove the rear cover by prising off using a at blade in the slot at the bottom edge.
• Insert the batteries noting the correct polarity and replace the cover.
• Drill the wall in the required location with regard to any concealed wiring or pipework,
use a wall plug if required and screw in a dome head screw leaving the head 4mm
proud of the surface.
• Locate the keyhole slot in
the rear of the light unit over
the screw head and ensure
the light is securely xed.
IMPORTANT SAFETY INFORMATION
INSTALLATION
Keyhole slot Batteries

OPERATION
MAINTENANCE
SPECIFICATION
• The motion sensor will turn on the light when movement is detected in low light
environments.
• After all motion ceases to be detected, the light will extinguish after 25 seconds.
NOTE: DO NOT press the motion sensor
- it is not a button.
• Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
Power supply: 3×AAA batteries (NOT included)
Material: ABS, PS
Light Source: 3×F5 LED
Output power: 18 lumen
Ambient light: <10LUX
Sensor distance: 0-3m
Sensor angle: 110°
Time delay: 25±2 sec (Auto-delay function)
Product weight: 42g
Product size H x W x D: 68×80×20mm
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
• Alternatively use the double sided adhesive pads to mount the light unit if the surface
is unsuitable for screw mounting.
110o
3m