Pro-Elec PELL0010 User manual

COB LED MOTION SENSOR LIGHT
PELL0010
Please read these instructions carefully before use and retain for future reference.
• Avoid locations of high temperature or humidity.
• If the light output becomes less bright or ashes, replace the batteries.
• Always remove the batteries if the light is not to be used for long periods.
• Never mix new and old batteries or mix different battery types.
• Separate the head from the mounting by gently pulling them apart then turn the rear
half on the head anticlockwise and remove it.
• Remove the battery cover and insert the batteries noting the correct polarity then
replace the cover and slide the switch to either on or auto position.
• Replace the rear half of the head unit then ret the head unit into the mounting.
IMPORTANT SAFETY INFORMATION
INSTALLATION
Switch

OPERATION
MAINTENANCE
SPECIFICATION
• In AUTO mode the motion sensor will turn on the light when movement is detected
only in low light environments.
• After motion ceases to be detected, the light will
extinguish after 25 seconds.
• When in the ON mode the light will remain
permanently lit.
• Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
Power supply: 3×AA batteries (NOT included)
Material: ABS, PS
Light Source: 1×1W COB LED
Output power: 120 lumen
Ambient light: <10LUX
Sensor distance: 0-5m
Sensor angle: 120°
Time delay: 25±2 sec (Auto-delay function)
Product weight: 132g
Product size H x W x D: 100×85×125mm
IP rating IP42
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
• Drill the wall or ceiling in the required location with regard to any concealed wiring
or pipework, use a wall plug if required and screw in a dome head screw leaving the
head 4mm proud of the surface.
• Locate the keyhole slot in the base of the light unit over the screw head and ensure
the light is securely xed.
• Adjust the angle of the head unit as required.