PROAIM CINEMA TP-QUADO User manual

1
What’s In The Box
Please inspect the contents of your shipped package to ensure you have received everything that is listed
below.
1
Quado 4-Leg Mitchell Camera Tripod Stand (TP-QUADO)
Assembly Manua l
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any means,
electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permied by the applicable copyright
statutes or in wring by the Publisher.
Bag Packing
Quado 4-Leg Mitchell
Camera Tripod Stand

2
 Loosen the telescopic ratchet knob of the
Quado Stand to extend the legs.
Note: Quado stand has an angle marking of
0-9 on all the legs. Angle markings make sure all
the stand legs are out at the same angle.
 Loosen the leg rotang knob of the quado
stand, open all four legs equally according to
the requirement and ghten the knob back.
 Tighten the ratchet knob to the desired angle
according to your setup requirements.
Quado 4-Leg Mitchell Base Stand Setup
Note: Quado can go down at on the oor as
4" and funcon just as low as a hi-hat, or as a
1'6" mini stand or go up as high as full 3'9"
height.
Fluid Head Mounng on Quado Stand
 To mount a 100mm or 150mm or any other
uid head (Not-Included) on the Quado
Mitchell Base Stand, you must rst install a
150mm bowl mount (Not-Included), as
shown in the images.
Note: Four locking knobs help to set the Stand
legs accurately and rmly. In addion, a
toothed locking mechanism on the top of the
legs helps securely lock the legs at the desired
posion.

3
YOUR PROAIM QUADO 4-LEG MITCHELL CAMERA TRIPOD STAND
ALL DRESSED UP AND READY TO GO!
(SHOWN WITH OPTIONAL ACCESSORIES)
Warranty: We oer one year warranty for our products from date of purchase. Within this period of me,
we will repair it without charge for labor or parts. Warranty doesn’t cover transportaon costs nor does it
cover a product subjected to misuse or accidental damage. Warranty repairs are subjected to inspecon
and evaluaon by us.
Liability: We are not liable for damage caused by products that we do not supply or from mishandling in
transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than our company.
Contact Us: In case of any kind of dissasfacon, please Contact us immediately and we promise our ut-
most support and care unl you use our product.
Note: It works eciently with equipment such
as Camera Slider and Geared Heads. When
using with Sliders, open the legs as per the
length of the Slider for beer Stability.
 To mount 150mm uid head (Not-
Included) , insert it into the bowl through the
screw and secure it with the knob at the
boom. Now you can mount the camera set-
up as per your requirement.