Probewell ST-3 User manual

QUICK START GUIDE

Installing the ST-3/XT3
Follow the procedure described in the Installaon of the ST-3/XT3 secon from its User Guide.
REMINDER: Make sure to configure the removable twist tabs and that the form selector switch
is set up according to the meter base form you are tesng.
Insert the ST-3/XT3 to the meter base and turn on the device using the ON/OFF switch.
ST-3/XT3 Quick Start Guide
Connecng to the ST-3/XT3 with a mobile device
1 To connect, start the Probewell Connect
applicaon on your mobile device.
2 Scan QR code on the device for a first use.
Minimum system requirements: iOS 11 or Android 7.
Connecng to the ST-3/XT3 with a computer
1 To connect, go to Windows Sengs, select
Network & Internet.
A Click on Show available networks
(Tip: shortcut oen located on the boom
right of your screen)
B Scroll down at the end of the list, select
Hidden Network or Other Network
C Input the socket SSID located below
the QR code and click Next
(i.e., PW-XT3-{S/N}-AP).
2 Start the Probewell Connect* applicaon
from your computer.
* To download and install the Probewell Connect app
for Windows, visit: www.probewell.com/pw-connect
(Minimum system requirement: Windows 10)
Not e: The device only allows one user to connect at a me.
Download the
Probewell Connect
mobile applicaon
Version 1.0
1-866-626-1126
[e-mail]
www.probewell.com
PW-XT3-{S/N}-AP
Note: Once the procedure is
completed, the SSID will
remain available directly
from the network list menu in
the known networks on
Windows.
C
A
B
It is essenal that the User Guide be read thoroughly
before pung this product into service.