ProFusion QH-1 Owner's manual

1
IMPORTANT INSTRUCTIONS
OPERATING MANUAL
Quartz Radiant Tower Heater
Model No.: QH-1

2
READ AND SAVE THESE INSTRUCTIONS
Customer Service: 1-888-538-0082
Service Email: [e-mail]
READ CAREFULLY BEFOREATTEMPTING TOASSEMBLE, INSTALL, OPERATE OR
MAINTAIN THE PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION
FAILURE TO COMPLY WITH INSTRUCTION COULD RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE.
IMPORTANT INSTRUCTIONS
When using this electric unit, basic safety precautions should always
be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:
1. Read ALL instructions before using this unit.
2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater
yourself.
3. This heater is hot when in use. To avoid burns, DO NOT let bare skin touch
hot surface. If provided, use handles when moving this heater.
4. Keep combustible materials, such as furniture, pillows, bedding, paper, clothes,
and curtains at least 3 ft (0.9m) from the front of the heater and keep them
away from the sides and rear. DO NOT place towels or other objects on the
heater.
5. Extreme caution is necessary when any heater is used by or near children or
disabled and whenever the heater is left operating and unattended.
6. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to

3
authorized service facility for examination, electrical or mechanical adjustment,
or repair.
7. This heater is not intended for use in bathrooms, laundry areas and similar
indoor locations. NEVER locate heater where it may fall into a bathtub or
other water container. To protect against electrical hazards, DO NOT
immerse in water or other liquids.
8. DO NOT touch the control panel or plug with a wet hand.
9. DO NOT run cord under carpeting. DO NOT cover cord with throw rugs,
runners, or similar coverings. Arrange cord away from traffic area and where it
will not be tripped over.
10. DO NOT insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, DO NOT block air intakes or exhaust in any
manner. DO NOT use on soft surfaces, like a bed, where openings may
become blocked.
12. The heater has hot and arcing / sparking parts inside. DO NOT use it in areas
where gasoline, paint, explosive and/or flammable liquids are used or stored.
Keep unit away from heated surfaces and open flames.
13. Always plug heater directly into a wall outlet/receptacle .Never use with an
extension cord or relocatable power tap (outlet/power strip)
14. To avoid fire or shock hazard, plug the unit directly into a 120 AC electrical
outlet.
15. This heater must be plugged into a 120V, 15 amp (or more) circuit of its own.
Nothing else can be plugged into the same circuit. If unsure if you home
meets this specification, consult a certified electrician prior to use. Risk of
fire, overheat, malfunction, property damage, injury, or even death may
result if not adhered to!
16. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull
firmly on the plug, DO NOT unplug by pulling on the cord.
17. Always unplug the unit before moving or cleaning, or wherever the heater is
not in use.
18. Use only for intended household use as described in this manual. Any other
use not recommended by the manufacturer may cause fire, electric shock, or
injury to persons. The use of attachments is not recommended or sold by
unauthorized dealers may cause hazards.

4
19. Always use on a dry, level surface.
20. DO NOT use outdoors.
21. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit
with any solid-state speed/dimmer control device.
22. DO NOT attempt to repair or adjust any electrical or mechanical functions on
this unit. Doing so will void your warranty. The inside of the unit contains no
user serviceable parts. Only qualified personnel should perform all servicing.
23. CAUTION: Use supply wires suitable for 105°C.
24. DO NOT locate against walls or behind drapes or furniture when it is free-
standing used.
25. The heater is not to be used in wet or moist locations.
26. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction regarding
use of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the appliance.
SAVE THESE INSTRUCTIONS
PRODUCT INFORMATION
Reflective heating technology replicates the sun's healthy rays, directly warming
the object or person in front of the heater. As the temperature of the heated
surface rises, the warming effect is felt throughout the air and surrounding areas.
Reflective heaters are great for open or large rooms, and actually save you
energy by warming objects and not the entire room.
Reflective heating is both safe and healthy-it produces no odors, chemicals, or
fumes, and doesn't stir up dust. As a safety feature, the heater's exterior does not
get as warm to reduce the risk of burns from anyone or anything touching the
heater while in use. Remarkably efficient, our heater uses less power to create
the same amount of heat as traditional heaters. Equipped with safety tip-over
switch and overheat auto-off, the heater is safe and reliable.

5
SAFETY FEATURES
Polarized Plug
Warning: This appliance has a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this plug is
intended to fit into a polarized outlet only one way. If the plug does
not fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to modify the plug in
any way.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED
PLUG.
Tip-Over Switch
Your heater is designed to automatically shut off when tipped forward or
backward. When returned to normal upright position, heat will automatically
come on again. This is a safety feature to avoid possibility of fire should the
unit be accidentally tipped.

6
PRODUCT DIAGRAM
OPENING INSTRUCTIONS
1. Carefully remove the heater from carton and the bag. Make certain the unit
is in the OFF position before plugging the heater into the power outlet.
+ -

7
2. Before using the heater, make sure that it is on a flat and stable surface.
Damage may occur if it is placed in an incline or decline.
3. Turn off all the controls of the heater, and then plug the heater power cord
directly into a standard grounded AC outlet. Be sure plug fits tightly into outlet.
4. To completely shut the heater off, turn all the controls to OFF, and remove
plug from the socket-outlet.
Power setting
1. Main Power Switch: Use this switch to turn the product on and off.
2. Heat Setting Switch: Use this switch to set the heat setting
"0" ("0" - off, no heat)
"1" –Low Heat Setting (600 Watts)
"2" –High Heat Setting (1200 Watts)
3. Turn the Thermostat Control Knob clockwise to its maximum range. The
Power Indicator will illuminate, indicating the Heater is on.
4. Allow the product to operate until the ambient room temperature reaches
the desired comfort level.
5. Slowly turn the Thermostat Control Knob counter-clockwise until the
product turns off. The product will cycle on and off to maintain the setting.
6. To adjust the thermostat, turn the Thermostat Control Knob towards
maximum to increase the set ambient temperature and towards minimum to
decrease it.
7. Turn off the product by rotating the Main Control Knob to the “0” position,
and then unplug the product from the electrical outlet.
Note: Do not force knob beyond its normal stop position.
MAINTENANCE
1. Unplug the unit and let it cool completely.
2. To keep the heater clean, the outer shell may be cleaned with a soft, damp
cloth. You may use a mild detergent if necessary. After cleaning, dry the unit
with a soft cloth.

8
CAUTION: DO NOT let liquid enter the heater.
3. DO NOT use alcohol, gasoline, abrasive powers, furniture polish, or rough
brushes to clean the heater. This may cause damage or deterioration to the
surface of the heater.
4. DO NOT immerse the heater in water.
5. Wait until the unit is completely dry before use.
STORAGE
Store the heater in a cool, dry location when not in use. Preferably, to prevent
dust and dirt build-up, use the old packaging to repack the unit.
TROUBLESHOOTING
If the heater will not operate, please check the following before seeking repair of
service:
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the main fuse is working.
3. Confirm that the Power Knob is turned to"1"or "2"
4. Check your thermostat setting. The heater may be off because it has reached
the desired temperature setting.
5. Check if the heater is on a level surface. If the tip-over safety switch is not
pushed in, the heater will not run.