UZK12.071/ UZB12.071/ UZO12.07
– U-Series Battery Module 12V, 7Ah
September 2006 / Rev. 1.0 / DS-UZK12.071-EN / All parameters are specified at 25°C ambient unless otherwise noted.
The information presented in this datasheet is believed to be accurate and reliable and may change without notice.
www.pulspower.com Phone +49 89 9278 0 Germany
1/1
BATTERY MODULES
A modular concept allows the user to meet individual
application demands and is available with two different
options:
You can order the module with an assembled battery or
you can choose only the bracket allowing the mounting
of individual batteries such as long life or higher current
which achieves a longer buffer-time. The mounting
bracket allows the battery to be assembled just in time
avoiding outdated batteries due to limited shelf life.
■Two mounting options:
DIN-Rail or panel/wall mounting
■Easy access to the terminals and the fuse
■Heavy duty fuse holder and spare fuse included
DATA DATA
Battery
Maintenance free valve regulated lead acid battery
Battery voltage nom 12Vdc
Battery capacity nom 7Ah
Self-discharge typ 3%/ month at 20°C
Design life (EUROBAT) 3 to 5 years
Fuse
Blade terminal fuse nom 30A ATO®
(257 030 Littelfuse)
Terminals and Wiring
Type Screw terminals
Solid wire nom 2.5-4mm2
Stranded wire nom 2.5-4mm2
American wire gauge max 12 AWG
Wire stripping length nom 7mm / 0.275”
Tightening torque nom 0.8Nm / 7lb.in
Ambient Temperature
Operation min +0°C to +40°C
Storage and transport min -20°C to +50°C
Instructions for Use and Disposal of the Battery
Place the battery module outside the cabinet or in the
coolest area when used inside the cabinet.
Use wires no smaller than 2.5mm2(or 12 AWG) and not
longer than 2x1.5m (cord length 1.5m).
Disconnect battery fuse before working on the battery
or on the DC-UPS.
To replace battery, loosen screw with only one turn and
slide the mounting bracket up.
For storage, installation and operation, the
requirements of the EN 50272-2 as well as other
national regulations must be observed.
Ensure sufficient ventilation for the battery.
Always dispose the batteries through a recycling
organisation. Batteries must be completely discharged
before recycling.
Dimensions and Weight (UZK12.071)
Width nom 155mm / 6.1“
Height nom 124mm / 4.88“
Depth nom 112mm / 4.41“
Weight max 3200g / 7.06lb
The DIN-rail height when used must be added to the depth
to calculate the total required installation unit depth.
Warranty
3 Year limited warranty except battery as battery is
considered as a service part. Special conditions are part of
our general terms and conditions. Do not store the battery
longer than 9 month without supplementary charge or
performance might change.
ORDER NUMBERS MARKINGS
UZK12.071 Battery module with battery
