PULSEEIGHT P8-HDBT-L-SP4 User manual

P8-HDBT-L-SP4
QUICK SETUP GUIDE
Power Use the supplied mains power cable and
connect to the device. Do not use any other power
cables with this product.
Ethernet Connect to system to your router or
network switch. This must be done in order to use
the remote monitoring portal.
HDMI Input Connect a HDMI source device
(i.e Blu-Ray player) to this port using a HDMI
cable (not supplied).
Infrared Output Connect the supplied IR
emitter to this port to control source device
Stereo Output 3.5mm audio breakout
HDBaseT Outputs Connect sink devices
(i.e TV) to the outputs via CAT cable. Complete the
connection by attaching a neo:Lite Reciever (sold
seperately) to the CAT cable and link to sink device
via HDMI cable (not supplied).
A
D
E
F
B
C
A B C D E

COPYRIGHT NOTICE
No part of this document may be reproduced, transmitted, transcribed,
stored in a retrieval system, or any of its part translated into any language
or computer le, in any form or by any means (electronic, mechanical,
magnetic, optical, chemical, manual, or otherwise) without express
written permission and consent from Pulse-Eight Limited.
© Copyright 2019 Pulse-Eight Limited. All Rights Reserved.
Version 1.0 - August 2019
Pulse-Eight Limited
8-12 Alder Hills . Poole . Dorset . BH12 4AL . UK
[e-mail] | [phone]
www.pulse-eight.com
INITIAL SETUP
1CONNECT INPUT DEVICE
Using the ‘HDMI Input’ port, connect to the source device
(i.e Blu-Ray player) using a HDMI cable (not supplied).
2CONNECT ETHERNET
Connect a standard Ethernet cable to the ‘Ethernet’ port
from your router or network switch, cross over cables are
not supported.
3CONNECT OUTPUT DEVICES
Sink devices are connected via CAT cable from the
Output port to a neo:Lite receiver (supplied seperately).
Complete the connection from the receiver to the Sink
device (i.e. your TV) via a HDMI cable.
4CONNECT INFRARED
Using the supplied IR emitter, connect to the IR out port
on the splitter and place the bud over the IR window on the
source device.
5CONNECT POWER
Use the supplied power supply, connect to the DC 48V
port. Ensure the source and sink devices are powered on
before powering on the splitter.
6REMOTE MONITORING
This device can also be registered on our Remote
Monitoring Portal via monitoring.pulse-eight.com