Punkt MP 02 Instruction Manual

Scroll Up
Volume Up when on call
Scroll Down
Volume Down when on call
Power on/off
(Press and hold)
Unlock Screen
(Press )
Mute
(Long press)
Receiver
Loudspeaker
°
Microphone
(Do not cover)
USB Type-C for charging and headset
Noise Cancelling
Microphone
(Do not cover)
Punkt.
(Opens main menu, select)

A. SEND
Answers incoming call.
LONG PRESS during incoming
call will answer with
speakerphone on.
Places a call to the valid dialled
number valid number in focus.
During an active call, toggles Hold
On/Off.
When on the Home Screen,
opens Call History.
B. END
Ends a call and/or navigates to
the home screen
C. BACK
Navigates back one step
Navigates back one step or clears
characters when in an editor
D. UP
Moves content into focus or
moves focus.
For number type settings, in-
crements or decrements.
In texting modes (messages,
notes, contact details) moves the
cursor left, to the start of text. If
cursor is at the beginning of text,
then the focus moves up.
LONG PRESS:
From Home screen takes you
directly to Connectivity menu
Otherwise moves to the top
menu element, or beginning
of texts.
E. PUNKT
From Home Screen: opens
the main menu
Selects the item in focus.
If reading message thread,
brings directly to new
message composition box.
F. DOWN
Moves content into focus or
moves focus.
In texting modes moves the
cursor right to the end of the
text. If cursor is at the end of
text, then the focus moves
down.
LONG PRESS moves to
bottom menu element or to
the end of texts.
G. CONTACTS
Opens contacts app.
LONG PRESS:
oOn Home Screen to
create new contact
oOn an unsaved
number, to save the
contact.
H. MESSAGE
Opens messages app.
LONG PRESS: On Home
Screen opens Message
Composer.
When focused on a number or
contact the Message
Composer will open with the
recipient pre-entered.
I. 1 (ONE)
LONG PRESS dials voicemail.
SHORT PRESS followed by
SEND dials voicemail.
J. * (ASTERISK)
LONG PRESS: Toggles mute
on/off during an ACTIVE CALL
In texting modes opens the
Special characters panel.
K. 0 (ZERO)
LONG PRESS:
oEnters “+” symbol in
dialer or numeric editor
mode.
oEnters “0” in text mode
One press creates a space in
text mode
L. # (HASH)
In texting mode alternates the
text input between Predictive
Input and Multi Tap; in the
following loop order:
Abc P.I. -> ABC P.I. -> abc P.I.
-> Abc MT -> ABC MT -> abc
MT -> 123

1.
I

MP 02 Mobile Phone
Safety and Product Information
Read more about how to use your MP 02 phone at www.punkt.ch/en/products/mp02-mobile-phone
Safety
Before you use your MP 02, read the following safety guidelines.
Turn off your phone in restricted areas
Turn off your phone in areas where the use of mobile phones is not allowed, or when it may cause
interference or danger.
Be safe on the road
Obey all local laws. Never operate the phone while, unless you are permitted by local law to use a hands
free device.
Radio waves can cause interference
MP 02 emits radio, which may interfere with other electronic devices. Interference from other electronic
devices may affect your network signal.
Keep your phone dry
The MP 02 is splash proof, but is NOT water-resistant. Keep it dry. Do not use or store the device in wet
conditions, Avoid humidity, moisture and all types of liquids to prevent possible corrosion of electronic
circuits.
Qualified service
Do not open, dismantle or modify your phone, except for tasks described in this user guide.
Never use the device if it is damaged. Only qualified personnel may repair this product.
Protect your hearing
Continuous exposure to loud volume settings may damage your hearing. Do not hold the device near
your ear in loudspeaker mode. If you use a headset, take care as excess volumes and sound pressure may
damage your hearing. Headset usage may affect your ability to hear outside sounds and may lead to lack
of attention.
Battery and charger
The MP 02 is fitted with a NON removable battery. Do not attempt to replace the battery. Use only
approved chargers and other accessories. Do not connect incompatible products.
SAR
This device meets RF exposure guidelines when used either in the normal use position against the ear or
when positioned at least 0.2 inches (5 mm) away from the body. When any form of device holder is used
for body-worn operation, it should not contain metal and should provide at least the above-stated
separation distance from the body. Note that mobile devices may be transmitting even if you are not
making a voice call

Glass parts
The device screen is made of glass. Do not drop, impact, or shock your device. If the glass breaks, do
not touch or attempt to remove the broken glass from the device. Stop using the device until the glass is
replaced by qualified service personnel.
Antenna locations
When you use your phone, hold it so your hand does not cover the antenna area. If you cover the antenna
area, it may affect your network signal
Network Service and costs
Using some feature or services like tethering, synchronising or backing up your contacts, require a data
connection. This may cause the transfer of large amounts of data, which may result in data costs.
Emergency calls
Emergency call numbers vary by location.
! Important: A network connection in all conditions cannot be guaranteed. DO NOT rely only on your
MP 02 for emergency communications.
To making the call switch the phone on, unlock the phone if locked. Ensure you have adequate signal
strength. Press the end key repeatedly, until the home screen is shown.
Dial the official emergency number for your location. Press the call key. Give the necessary info as
accurately as possible. Do not end the call until given permission to do so.
All antenna locations are highlighted

Caring for your MP 02
Handle your device and accessories with care. Store the device between 15°c and 25°C for optimal
performance and battery life. Do not store the device in extreme temperatures, lower than 0 °C or higher
than 40 °C. Exposure to extreme temperatures may cause the phone not to work temporarily, continued
exposure may damage the device or battery. Do not store or use the device in dusty or dirty conditions.
Only use a soft, clean, dry cloth to clean the surface of the device.
Keep the device away from magnets or magnetic fields.
Keep your phone away from sources of heat.
Recycling and crossed-out wheelie bin symbol
Separate electronic equipment, batteries and packaging materials at end of working life. Do not dispose
of these products as unsorted municipal waste. Take them for recycling at dedicated collection points.
Charger and battery info
Hold and pull the plug, not the cord to unplug the charger (or any accessory). Unplug the charger when
not in use. Only use the charger indoors. Do not charge your device during a lightning storm. Use the
charger for its intended purposes only.
A fully charged battery will lose its charge over time when not in use. Do not dismantle or damage the
battery in any way. If a battery leaks, do not let liquid touch skin or eyes. If this happens, immediately
flush the affected areas with water, or seek medical help. Do not modify, attempt to insert foreign objects
Do not expose the MP 02 to fire, the battery may explode Use only approved chargers and other
accessories. Do not connect incompatible products. Never use a damaged battery or charger
Choking hazard
Keep your device out of the reach of small children. The device and its accessories are not toys. They
may contain small parts.
Medical devices and hearing aids
Keep your MP 02 away from medical device, including pacemakers and hearing aids, they might
malfunction and cause serious harm or death
Explosive environments
Do not use your device in potentially explosive environments, such as near gasoline pumps. Sparks may
cause an explosion or fire resulting in injury or death.
Setting a PIN for your SIM card
The PIN for your SIM card must be at least four numbers.

Warning: Do not try to guess the PIN for your SIM card. If you enter the wrong PIN three times, then
your SIM card becomes locked. If your SIM card is locked, request a Personal Unlocking Key (PUK)
from your network provider.
Setting a passcode for your phone
Phone passcodes can have up to six digits. The default passcode is XXXXXX If you change the default
passcode do not forget it, otherwise it may lead to loss of all personal data and incur costs to have the
phone firmware reflashed.
Regulatory compliance
Compatibility with hearing aids (HAC)
RF exposure information (SAR)
The exposure standard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR.
This mobile device meets international guidelines for exposure to radio waves when used as follows:
Against the ear: Place or receive a device call and hold the device as you would a wire line
telephone.
Body worn: When transmitting, place the device in a carry accessory that contains no metal and
positions the device a minimum of 1.5 cm from your body. Use of other accessories may not ensure
compliance with radiofrequency exposure guidelines. If you do not use a body worn accessory and
are not holding the device at your ear, position the device a minimum of 1.5 cm from your body.
Data operation: When using a data feature, position the phone a minimum of 1.5 cm from your
body for the whole duration of the data transmission.
ICNIRP SAR certificate information
The ICNIRP SAR limit for mobile devices is 2.0 W/kg averaged over 10 grams of tissue.
SAR tests are carried out with the device in standard operating positions, transmitting at its highest
certified power level, in all its frequency bands. The maximum recorded SAR values for this device
are:
Maximum SAR value
Frequency Bands used when Maximum SAR
value was recorded
When held against the head
When operated at a separation
distance of 0.5 cm from the body
USA & Canada (FCC ID: XXXXXXX)
This mobile device is designed to meet Federal Communications Commission (FCC) and Industry
Canada SAR requirements. The SAR limit set by the FCC is 1.6 W/kg.averaged over 1 gram of tissue.