QOLSYS IQ MOTION S-LINE User manual

IQ MOTION S-LINE QUICK INSTALL GUIDE
SEE REVERSE FOR REMAINING STEPS
STEP
1
CHOOSE
INSTALLATION
LOCATION
DETECTING AREA
(Unit = meter) 40lbs at 35’
Replace battery every 5 years with AAA
Alkaline (x2)
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
X
Avoid placement
looking at ceiling
fans
✓
Outside walls
pointed away from
windows are great
locations
X
Avoid
HVAC
ducts &
drapes
X
✓
Install at
6.5’ high
✓

STEP
2
REMOVE
BATTERY
TABS
STEP
4
CHOOSE
MOUNTING
TYPE
SECURE
ALL
HARDWARE
LEARN
INTO
PANEL
Document#: IQM-SQG-03-17
Revision#: 3/22/17
Issue Date: MAR 2017
Qolsys Part #: QS-1230-840
STEP
5
OPEN
DEVICE
CASING
STEP
3
STEP
6
Place your panel in
“autolearn" mode
Open and close the case
to “tamper” the device
Customize name and settings
as desired and and touch “ADD”
ADD
Tech[email protected]
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2AAJXQS1200
IC: 11205A-QS1200
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,!
including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and !
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et!
(2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
CONTACT TECH SUPPORT
GOT QUESTIONS?
ANGLED
FLAT
ANGLED
CORNER
MOUNT AT
6.5 FEET HIGH
DO NOT USE
THESE MOUNTING
LOCATIONS