QOLSYS QS1115-840 User manual

STEP
1
IQ MINI DW QUICK INSTALL GUIDE
✓
Exterior Doors
✓
Sliding
glass
doors
Windows
✓
CHOOSE
INSTALLATION
LOCATION
Also great for:
Medicine cabinets
Gun safes
Garage doors
Interior doors SPECIFICATIONS
SEE REVERSE FOR REMAINING STEPS
This is a quick guide for experienced installers only. For a detailed installation manual refer to the documentation found on
the “Documentation” tab on http://dealers.qolsys.com (login required, request access at [email protected])
Sensor: 2.25”H x 1”W x .5”D
Wireless signal range: 600ft (200M), open air.
Code outputs: tamper, tamper restore, alarm, alarm
restore, low battery.
Transmitter frequency: 319.5 MHz
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m
Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C
Replace battery with exact replacement every 5 years
with 3V Lithium (x2).
(2) -Panasonic CR2032
-Energizer CR2032
-Duracell DL2032

STEP
2
STEP
3
REMOVE
BATTERY
TABS
STEP
4
LINE UP
SENSOR &
MAGNET
STEP
5
SECURE
SENSOR &
MAGNET
STEP
6
LEARN
INTO
PANEL
✓
Touch
“Settings”
Tamper sensor by
opening casing until you
hear the panel chime
Select “Door/Window” as
your sensor type and
customize settings as desired,
then touch Add
Test sensor to
ensure proper
function
Touch
“Installation”
Touch
“AutoLearn
Sensor”
Touch “Security
Sensors”
Document#: IQMDW-QG-04-15
Revision#: 5/7/15
Qolsys Product #: QS1115-840
GOT QUESTIONS?
CONTACT TECH SUPPORT
[email protected]
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
Apply provided
adhesive strips to
the back of
sensor and
magnet.
Magnet gap
should not
exceed 3/4”
Magnet locator mark
Magnet
Sensor
APPLY
ADHESIVE
3/4”