Quadratec 13111.0401 Quick guide

Mirrors for Jeep vehicles 1955-Current
Installation and Instruction Manual
#13111.0401 (Round Head) and #13111.0400 (Square Head)
REQUIRED TOOLS:
SAFETY GLASSES
14MM WRENCH
12MM WRENCH
11MM WRENCH
KIT CONTENTS LIST:
MIRROR HEADS & HARDWARE (2 EACH)
MIRROR ARMS (2 EACH)
NYLOC NUTS (2)
NYLON WASHERS (4)
STEEL WASHERS (4)
READ ALL SAFETY MESSAGES AND UNDERSTAND ALL
INSTRUCTIONS AND PROCEDURE NOTICES BEFORE
ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
Q_ADV_MIR_13111_040X.qxp_A4 4/14/16 4:07 PM Page 1
04142016160821

Step One: Remove Doors
Put on safety glasses. Start by removing
your Jeep doors and locating the upper
door hinge on the driver’s side.
Step T wo: Install Mir ror Arm
Install a metal washer and then a nylon
washer onto the threaded end of the
.1erugiFninwohssamrarorrim
As shown in Figure 2, install the mirror
arm into the door hinge and then from
the bottom, install another nylon and
steel washer, followed by a nyloc nut.
Make sure the nylon washers are sand-
wiched between the steel washers and
in contact with the door hinge so as not
to damage the paint on the vehicle.
As shown in Figure 3, tighten the
Nyloc nut using a 14mm wrench or
socket while holding the mirror arm
in place. Tighten until the arm is snug
in the door hinge but not so tight that
it cannot be adjusted.
READ ALL SAFETY MESSAGES AND ALWAYS WEAR
SAFETY GLASSES WHEN WORKING WITH TOOLS.
Figure 1
Figure 3
Figure 2
Q_ADV_MIR_13111_040X.qxp_A4 4/14/16 4:07 PM Page 2
04142016160822

Step Three: Install Mirror Head
Install the Mirror head depending upon
round or square design. Tighten the
round mirror head with a 12mm wrench
on the bolt head and an 11mm wrench
on the mirror barrel. Tighten the square
head design with two 12mm wrenches
on the jam and acorn nuts.
The tension of the mirror head can be
adjusted using the 3 phillips head
screws on the backside of the mirror.
DO NOT OVER TIGHTEN. The mirror
should not be so tight that it cannot be
adjusted. Adjust mirror then check and
snug all fasteners. Repeat steps for the
passenger side mirror.
Round Head Mounting
12mm
11mm
Square Head Mounting
12mm
Q_ADV_MIR_13111_040X.qxp_A4 4/14/16 4:07 PM Page 3
04142016160823