Quoizel GRD8405W User manual

Package Contents
1of2
For Style GRD8405W
ACrossbar
x1
Pleasegoto forproductcleaningtips.Gotothe selection.
LED18W
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
LightSource:
EstimatedAssemblyTime:
Preparation:
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Fixture Body
x1
Figure 1
STEP 1 -Install the Crossbar to the junction box
A. Attach the Crossbar (A) to the Outlet Box with the head of the Green
Ground Screw facing you. Secure it with Outlet Box Screws (not
included), tighten until snug.
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Installation Guide #IS-GRD8405W
2018 QuoizelInc. ReleasedDate:2018-08-29
visit us on-line at www.quoizel.com
Mounting Screw
x2
B
C
Outlet Box Screws
(not included)
A
Supply Wires
with Ground Wire
Green Ground Screw
Outlet Box
Figure 3
STEP 3 -Install the Fixture Body
A. Place the backplate of the Fixture Body (C) onto the Crossbar (A)
and secure with Mounting Screws (B). Tighten until snug with
screwdrivers.
Backplate
B
C
A
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Figure 4
STEP 4 -Apply Silicone Sealer
A. Make sure the exterior wall surface and fixture backplate are free of
dirt before applying caulk. Using exterior grade caulk, caulk over top
of backplate and down both sides. Do not caulk the bottom of the
fixture backplate to ensure proper moisture drainage.
Your fixture is now assembled and ready to use. Enjoy!
Backplate
C
Exterior Grade Caulk
Exterior Grade Caulk

2of2
2018 QuoizelInc. ReleasedDate:2018-08-29
visit us on-line at www.quoizel.com
GRD8405W
FINISH: FRESCO
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4"
5.75”
4.5” Dia.
14” 5.25”
7”
5.25”