QVC MYSafe 911 User manual

+
Insert batteries (included) into
battery compartment per diagram.
Press right side battery check
button for 2 seconds. Front LED light
will temporarily light green if
batteries are ok. LED light will light
red if batteries are low. If the LED
light is not on, recheck the position
of the batteries and repeat until
green or red light is on.
To call 911, press and hold the call
button for (front button with large +
symbol) 5 seconds until you hear
the device say CALLING 911 and
the LED light will show blue. The
device will connect to 911 operator.
If call fails to go through, you will
hear DISCONNECTED, REDIAL
and device will retry calling 911
until an operator can be reached.
To disconnect, press left side
CANCEL button or wait for operator
to hang up. Once disconnected
blue LED light will turn off.
This device is designed to call 911 ONLY.
It is recommended to check battery every 2 weeks. Front LED light will light red if batteries need to be
replaced. Replace with AAA batteries.
This unit does not provide location. Please let the operator know your exact location. Additionally, this
unit does not allow for call backs and will appear as an unregistered device to the 911 operator.
BATTERY
Compartment
CANCEL
Button
BATTERY
CHECK
Button
CALL
Button
INSTRUCTIONS
ALARM SETUP
ALARM OPERATION
Blue LED Light = Call in progress
Green LED Light = Battery good and device
in standby mode for calling 911
Red LED Light = Batteries low. Replace
batteries.
LED LIGHT INDICATORS
BACK
FRONT
LED Light
LEFT
SIDE
RIGHT
SIDE
Battery
Compartment
Battery
Compartment
NOTE
A
AB
B

FCC Compliance
For body-worn, this equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment And for talking mode, 10mm was used for test, this equipment
should be installed and operated with minimum distance 10mm. This transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter.
Specific Absorption Rate (SAR)
911 Help Now Plus meets the government's requirements for exposure to radio waves.
Your device is a radio transmitter and receiver. It is designed and manufactured to not
exceed limits for exposure to radio frequency (RF) energy set by the Federal Communica-
tions Commission (FCC) of the U.S. Government and by the Canadian regulatory
authorities. These limits are part of comprehensive guidelines and establish permitted
levels of RF energy for the general population. The guidelines are based on standards that
were developed by
independent scientific organizations through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin designed for the safety of all
persons, regardless of age or health.
The exposure standard for 911 Help Now Plus employs a unit of measure known as the
Specific Absorption Rate, or SAR, The SAR limit set by the FCC is 1.6 W/Kg. Tests for SAR
are conducted using standard operating positions accepted by the FCC with the device
transmitting at its highest certified power level in all tested frequency bands. Although the
SAR is determined at the highest certified power level, the actual SAR level of the device
while operating can be well below the maximum value. This is because 911 Help Now Plus
is designed to operate at multiple power levels so as to use only the power required to
reach the
network.
In general, the closer you are to a wireless base station, the lower the power output.
Before 911 Help Now Plus is available for sale to the public in the U.S. it must be tested
and certified to the FCC that it does not exceed the limit establish for safe exposure. The
tests are performed in positions and locations (e.g. at the ear and worn on the body)
reported to the FCC. While there may be differences between the SAR levels of various
devices and at various positions, they all meet the governmental requirements for safe
exposure. Please note that
improvements to this product model could cause differences in the SAR value for later
products, in all cases, products are designed to be within the guidelines. Additional
information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommuni-
cations & Internet Association (CTIA}
Web site: http://www.phonefacts.net
Any changes or modifications not expressly approved by the party responsible for
compliance
could void the user's authority to operate the equipment.