Rampage 14301 User manual

RAMPAGE
P R O D U C T S
14301 bracket installation
Jeep JK 4 door, 2007-
NOTE: Before installation please read and understand these instructions. Please be sure all
of the components are included in the package. Please be sure to have a helper to assist you
for the initial installation of the step assemblies.
(6x) 8mm bolts (6x) 8mm ID washer
(24x) 6mm ID washer
(12x) 6mm bolts (12x) 6mm nut (6 x) U Bracket
Left side brackets Right side brackets
(4x) 8mm Pinch clip
Parts List
Ratchet wrench with extension 10mm socket 10mm wrench 13mm socket
Tools Required
Thank You for purchasing this product!
Preperation
If the vehicle had factory step or rocker guard on it the pinch
clips will be installed on the floor of the vehicle already. If it did
not then they will need to be installed in the openings under the
vehicle as shown. Look for the square holes with a round hole
next to it. These mounting locations will require the pinch clips.
Slip them into the square holes and onto the round hole as
shown to the right.
(4x) 8mm Pinch clip
Vehicle floor
Vehicle floor
(4x) 8mm bolts

Locate the correct brackets for the positions on the side of the vehicle. Figure 1 below shows the required brackets
for the passenger side. The front two brackets are the same.
Place the brackets up underneath the vehicle aligning the holes in the brackets with the holes in the pinch weld and
floor of the vehicle.
Use the 8 mm bolts/washers to loosely install the brackets to the floor. Use the 6 mm bolts/washers/nuts through the
pinch weld holes, be sure to use a washer both on the outside of the pinch weld and the inside of the bracket.
(NOTE: Do not tighten the bolts at this time.)
Place the board being installed carefully on the brackets and use it to help align the position of the brackets on the
vehicle (NOTE: do not bolt up the board at this time). Now tighten the brackets, removing the board to tighten any
fasteners that are covered by it.
Repeat for other side.
Finish by installing the boards/steps onto the brackets
using the “U” Brackets and 6 mm bolts/washers as shown
in Figure 3. The U brackets clamp the sheet metal of the
steps and allow adjustment.
2
Warranty Information
Rampage products, Inc. warrants to the original purchaser of any step product it manufactures, that the product will be free of defects in material or
workmanship for a period of 1 year from date of purchase. Such obligations under this warranty shall be limited to the repair or replacement, at
Rampage products discretion, of any assembly or parts which, upon examination by Rampage products, Inc. proves to be defective. All defective
items must be returned with proof of purchase to Rampage products, Inc., freight prepaid. This warranty does not cover damage resulting from
abuse, misuse, alteration, accident or damage in transit. Rampage products obligations under this warranty are limited to the aforementioned repair
or replacement of warranty defects for which the return authorization has been received during the warranty period, and Rampage products, Inc.
shall not be liable for any incidental or consequential damages arising from breech of this or any implied warranty.
Rampage Products, Corona, CA Phone: [phone] Fax: [phone]
www.rampageproducts.com
3
Installation
Passenger side brackets and order
NOTE: the front two brackets
are the same on both sides.
Driver side brackets and order
Note slot size/location
Figure 1
Figure 2
Front of vehicle
Front of vehicle
Bracket
“U” Bracket
Step
6 mm Bolt
Flat washer
Figure 3