RealFlame Gabrielle L6700 User manual

gel replaces and accessories
Model # L6700
Gabrielle Fireplace
2
WARNINGS
!!!
Using your Fireplace
NOTICE: Buyer assumes all responsibility for safety and use
that is not in accordance with instructions and warnings.
- Fireplace is designed to be used indoors, there is no need for ventilation.
- Use extreme caution while burning. Some surfaces become extremely hot during use.
- Follow all instructions included with gel fuel before use.
- Before using fireplace, be sure you have read and understand the step-by-step instructions.
- During the initial burn you may experience a slight odor. Odor is temporary and will be absent on
following burns.
Welcome to the Real Flame family of gel fuel products. If
you have questions please call customer service at 1-800-
654-1704 or log on to www.REALFLAME.com
1. Fireplace is designed to be used with Real Flame®gel fuel only. Do not use with any other gel fuel or
any other flammable liquid or gel.
2. Read entire label and instructions before using Real Flame gel fuel.
3. Make sure fireplace is set on a flat, level and stable surface. Keep fireplace stable at all times.
4. Make sure fireplace and gel fuel are burned on a flat and level surface.
5. Never leave a burning fire unattended, especially around children or pets.
6. Fireplace is not to be operated by children. Keep away from children and pets.
7. Exercise the same precautions as you would with any open fire.
8. When in use some surfaces will be hot, use caution.
9. Never touch logs, gel fuel cans or any other metal surfaces during or immediately after burning gel
fuel. They will be extremely HOT. Allow them to cool for 60 minutes before touching.
10. Do not burn more than three cans of fuel at once.
11. Do not place more than 15 lbs. of weight on the top of the fireplace at anytime.
12. Do not alter fireplace, metal firebox or log set in any manner.
13. Keep fireplace and gel fuel cans away from flammable materials at all times.
14. Do not store or use gasoline or any other flammable vapors, liquids, or materials in the vicinity of
fireplace and gel fuel.
15. Do not wear flammable or loose clothing when operating the fireplace.
16. Do not move fireplace while in use. Do not attempt to move or store the fireplace until 60 minutes
after gel fuel cans have been extinguished.
17. Do not burn trash, paper, or wood in the fireplace. Burn only Real Flame®gel fuel in the fireplace.
18. Do not burn gel fuel outside designated burn areas on the metal grate.
19. Do not put fireplace in an area with lots of traffic, such as a hallway or entryway.
20. In case of an emergency use a CO2 extinguisher to extinguish the fire.
21. Death, serious injury or damage to property may occur if the warnings above are not followed.
22. If for any reason you cannot follow these warnings please call us at 1-800-654-1704.

3
Parts List
Number Description Part Number Quantity
1 Base 6700-01 1
2 Left Side Panel 6700-02 1
3 Right Side Panel 6700-03 2
4 Left Trim Panel 6700-04 1
5 Right trim Panel 6700-05 1
6 Center Panel 6700-06 1
7 Mantel Top 6700-07 1
8 Center Trim Panel 6700-08 1
Not Shown:
Screws 9716 Bag
Before assembly, locate instructions and hardware. Take out all parts
and compare them to the photograph and the assembly illustrations. Be
sure you have all parts identified.
Check for screws that are wrapped in the packaging to be sure you don't
discard them. You may have extra screws.
A helping hand is always good. Assemble fireplace with an adult
assistant if possible.
The cement log is heavy. Put the fireplace in the desired location before
inserting cement log.
Use caution not to over tighten screws.
Step One
- Set base (1) on a at surface.
- Using tongue and groove t the Right Side Panel (3) into the Right
Trim Panel (5). Make sure the bottom edges of the Right Side Panel
and Right Trim Panel are ush. Attach together with 3 screws through
mounting blocks.
- Repeat with Left Side Panel (2) and Left Trim Panel (4).
- Place assembled Right Panels on base with mounting block on
the inside of Right Side Panel (3) against inside of base as shown in
gure 1. Attach with 3 screws.
- Repeat process using Left Side Panels.
4
Figure 1

6
Step Three
- Set Mantel Top (7) on top of unit so trim hangs over the front and sides.
- First attach through the holes in the center panel and front panels, then
through the holes in each side panel.
You are now ready for the firebox
installation. Please refer to the
instructions that are included with
your firebox.
Figure 3
Step Two
- Attach the Center Panel (6) to the side panels using the tongue and
groove construction as a guide. Attach the Center Panel to the side
panels using 4 screws through the mounting blocks. Top edge should
be ush with the side panels.
- Fit the Center Trim Panel (8) behind the Center Panel (6). Push down
on the Center Trim Panel so that the bottom of the Center Trim Panel
ts onto the tongue of the panel below it. Attach to the back of the
Center Panel and the Front Panels with 7 screws.
5
Figure 2