Red Kite push me fusion Manual

IMPORTANT
Keep these instructions for future reference. Your child’s safety
may be affected if you do not follow these instructions.
Instruction Leaet
Push Me Fusion
Stroller: This vehicle is intended for children from birth up to a maximum weight of 15kgs.
Complies with BS EN 1888 : 2012
Group 0 Rear Facing Infant Carrier: For infants up to 10kg (Group 0).
Conforms to ECE R44.04 Universal.
Customer Care Line: 01454 326 568
*Product available in
several colour options
Pram Mode Stroller Mode Car Seat Mode

Assembly instructions
To open and unfold the frame
Slide the primary lock button to the side,
squeeze the secondary lock trigger (Fig.1) and
lift the handle upwards until the frame locks in
place (Fig.2)
WARNING Ensure that all the locking devices
are engaged before use.
To attach the rear wheels
Push the axle unit onto the back legs (Fig.3)
ensuring the spring buttons have popped
through the holes (Fig.4).
Fig 2
2
3
4
1
Fig 1
1 Primary lock2 Secondary lock
Fig 3
Fig 4
Parts list
1 Frame and basket x 1
2 Bumper bar x 1
3 Rear wheels x 2
4 Front wheels x 2
5 Axle unit x 1
6 Stroller hood x 1
7 Stroller apron x 1
8 Car seat including head hugger
and harness pads
9 Car seat hood x 1
10 Combined seat/cot unit including
harness pads x 1
11 Reversible liner x 1
12 Raincover x 1 (not shown)
6
7
8
5
11
9
10
Stroller
handle
Axle unit
Back legs
Spring
buttons

Slide the spindle of the rear wheels into the
axle unit (Fig.5) and push inwards until they
lock in place (Fig.6) . The wheels can easily be
removed by pressing the button (Fig.7) and
pulling the wheel out.
To use the brakes
To use the brakes, push the lever down to
engage them and lift up to release (Fig.8) .
WARNING Apply all the brakes whenever you
park the stroller.
To attach and operate the front wheels
Slide the stems on the front wheels into the
wheel holders and push up (Fig.9) . To select
xed or swivel wheels, push the button on the
top (Fig.10) . To remove the front wheels, push
the wheel release button on the side and pull
the wheel down.
Fig 6
Fig 5
Fig 8
Fig 9
Fig 10
Rear
wheel
Axle unit
Fig 7
Button
Brake lever
Wheel holder
Front wheel
Wheel holder
Fixed / swivel button
Wheel release
button
Shoulder strap
Waist harness
A
B
C
Buckle housing
To adjust and secure the harness
Slide the waist harness (A) in to the
shoulder strap (B) and then push in to the
central buckle housing (C).
To release the buckles simply push
the button in the centre of the buckle
housing.
WARNING Always use the crotch strap in
combination with the waist belt.
Release button

Seat unit options
Straighten the bar under the seat unit and
secure in place with the Velcro tabs (Fig.11)
Seat unit mode: To use from 6mths plus (as
a seat), connect the 3 clips shown together
(Fig.12)
Carry cot mode: Undo all 3 clips to use it for
newborn. This provides a at cradle space for
use as a carry cot
To attach the bumper bar
Slot the ends of the bumper bar in to the holes
in the centre of the seat/cot unit and push down
until they click in place. To remove the bar, push
in the buttons on each side and pull out. You
can release one side of the bumper bar and
swivel it around to aid you in putting your child in
or taking them out of the seat unit.
(Fig.13)
To attach and operate the canopy
Push the brackets on the end of the hood on to
the seat/cot frame where the pin is and attach
the back of the hood by connecting the zip to
the back of the seat/cot unit. Simply push or pull
the front bar of the hood to open or close it.
(Fig.14).
Fig 11
Bars
Velcro tab Velcro tab
Fig 12 Seat unit - underneath
Clip 1
Clip 2
Clip 3
Fig 13 Bumper bar
Hood
Fig 14
Seat unit -
underneath

To attach the seat unit to the frame
Slot the adaptors on the seat unit to the
brackets on the frame (Fig.15) .
To rotate or remove seat unit
To reverse the seat unit or take it off, squeeze
the triggers on both sides and lift off (Fig.16) .
To attach the apron
Zip the apron onto the seat unit and wrap the
end of it around the bumper bar and secure
with the Velcro (Fig.17) .
To adjust the calf support
Push the buttons on both sides of the seat unit
and choose which position you would like the
calf support (Fig.17).
To recline the seat unit
Lift the lever on the back of the seat unit to
select a different position. Then raise or lower
the seat to the desired height and release the
lever. (Fig.18).
Car seat
The hood attaches to the car seat with 3 press
studs.
Attach the car seat to the stroller in the same
way as the seat unit by slotting the adaptors on
the seat unit to the brackets on the frame.
To raise or lower the handle press in the buttons
and adjust the handle (Fig.19).
To fold the stroller
Remove the car seat or seat unit from the
frame.
Lower the handle by sliding the primary lock
button to the side and then squeeze the
secondary lock trigger. (Fig.20) .
Just above the basket between the legs there
is a strap(Fig.21) pull the strap upwards and
this will lock the frame in a closed position.
Fig 16
Fig 15
Fig 18
Fig 19
Adaptor
Bracket
Seat unit
Frame
Trigger
Calf
support
adjustment
button
Fig 17
Seat unit
adjustment
button
Fig 20
Adaptor
Bracket
Car seat
Frame
Fig 21
Car seat
release button
Strap
Handle
Handle adjustment
button
Apron

General care:
• The correct use and maintenance of this stroller
is essential.
•Do not use excessive force when folding the
stroller.
•If you are having problems, fully open the stroller
and repeat the folding procedure.
•Always let wheels down as gently as
possible when mounting and dismounting kerbs.
•Always fold the stroller when going up or down
stairs.
•Never bump the stroller over these or similar
obstacles.
•In some climates mould and mildew can affect
the fabric and rain cover. To avoid this, do not
fold the stroller when it is wet. Leave it open in a
ventilated area until completely dry.
• Always store the stroller in a dry place.
•When storing the stroller in the car, never place
other items on top of it.
•Do not exceed the maximum load of 2 kgs in the
shopping basket. (Where provided).
Cleaning:
•Fabric covers and trims may be spot washed
using mild detergent and warm water. Leave to dry
in a ventilated area away from direct sunlight.
•Avoid leaving your stroller in direct sunlight for
prolonged periods of time as this may cause
fabrics to fade.
•Do not dry clean, machine wash or tumble dry.
•Metal parts may be cleaned with a damp cloth.
•Always wipe dry. Clean plastic parts with a mild
soap and water solution, wipe dry.
Maintenance:
•Maintain your stroller by lubricating all metal
moving parts with a silicone based spray. Do
not use heavy machine oil or grease as this can
attract dirt or grit.
•Check that nothing is loose or broken and that no
sharp edges have been exposed. Inspect all joints
and the harness, replace any damaged parts
immediately.
•Inspect any nuts and bolts regularly to ensure
none have worked loose. Tighten as necessary.
• Only use replacement parts and accessories
that have been approved by the manufacturer.
Failure to do this may invalidate your warranty.
Safety warnings:
WARNING Never leave your child unattended.
WARNING To avoid injury ensure your child is kept away
when unfolding and folding this product.
WARNING Do not let your child play with this product.
WARNING Always use the restraint system.
WARNING This product is not suitable for running or
skating.
WARNING Your child’s safety is your responsibility.
WARNING Any load attached to the handle affects the
stability of the pram / pushchair.
WARNING Check that the pram body or seat unit
attachment devices are correctly engaged before
use.
• WARNING Use a harness as soon as
your child can sit unaided.
• PRAM MODE: WARNING: This product is suitable for
a child who cannot sit up by itself, roll over and cannot
push itself up on its hands and knees. Maximum weight
of the child: 9kg.
• Not intended for children weighing more than 15kgs.
This stroller is designed for one child only.
• The brake must always be engaged when placing
and removing children from the stroller.
• Any load attached to the handle and/or on the
backrest and/or on the sides of the vehicle will affect
the stability of the stroller.
• Do not attach a buggy board or similar product for a
child to ride on.
• Lift a child in and out of the stroller. Do not allow a
child to stand on the footrest or seat.
• Do not use accessories that have not been
approved by the manufacturer.
• Never use the stroller to carry a child up and down
stairs or escalators.
• For newborns, it is advisable to use the seat unit in the
fully reclined position.
NOTE D rings have been provided for the attachment
of a separate safety harness approved to BS 6684 (if
required). The points for attachment are located on
the waist straps of the harness.
This product complies with BS EN 1888 : 2012
For all technical queries please call: 01454 326 568
Imported by: The Red Kite Baby Co Ltd, 35 Lavenham
Road, Beeches Industrial Estate, Yate, Bristol, BS37 5QX

Stroller / Travel System Important Safety Information:
•The stroller will not fold down with the car seat or seat unit attached.
•For new born babies we recommend using the stroller in Pram mode as this provides the most reclined
seat back position.
•
Seat unit intended for children from birth up to 15 kg. Use in pram mode for babies aged 0 - 6 months
and in stroller mode from 6 months until 15kg.
•This product is supplied with one raincover which ts the stroller in stroller and pram mode. Place the
raincover over the unit and secure with the elastic. We recommend allowing the raincover to dry before
folding and storing in the basket to prevent mould and mildew forming. A raincover is not supplied for the
car seat.
•
Padded liners are supplied with the seat unit and car seat. These can be removed by threading the
harness through the slots in the liner.
•
The xed wheel function makes using the stroller on uneven terrain easier. However, the stroller must
never be used on sand as this will severely damage the bearings in the wheels.
•The height of the shoulder straps can be adjusted by feeding the harness through the cut out holes
located on the seat unit.
•
WARNING! For babies aged 0 - 6 months the harness must be fed through the retaining holes to prevent
risk of strangulation.
•Never use the detached seat unit (in pram mode) as a carry cot.
•Never change the seat unit into pram mode with your child in the seat unit.
• WARNING! When in pram mode, do not use an additional mattress.
•Take extra care in windy conditions.
•Before folding the stroller check the following:
A Your child is clear of moving parts
B The rear brakes have been applied
C The front wheels are secured in the locked mode
D The seat unit or car seat has been removed
E All items have been removed from the basket
F Never attempt to close or fold the stroller with the child inside