Red Kite Push Me Twini User manual

SAFETY WARNINGS
• WARNING Never leave your child unattended.
• WARNING To avoid injury ensure your child is
kept a ay hen unfolding and folding this
product.
• WARNING Do not let your child play ith this
product.
• WARNING Al ays use the restraint system.
• WARNING This product is not suitable for
running or skating.
•WARNING Your child’s safety is your
responsibility.
• WARNING Any load attached to the handle
affects the stability of the pram / pushchair.
• Not intended for children eighing more than 15kgs. This
stroller is designed for t o children only. Total combined
eight of 30kg maximum.
• The brake must al ays be engaged hen placing and
removing children from the stroller.
• Any load attached to the handle and/or on the backrest
and/or on the sides of the vehicle ill affect the stability of
the stroller.
• Lift a child in and out of the stroller. Do not allo a child to
stand on the footrest or seat.
• Do not use accessories that have not been approved by
the manufacturer.
• Never use the buggy to carry a child up and do n stairs or
escalators.
• For ne borns, it is advisable to use the seat units in the fully
reclined position.
NOTE D rings have been provided for the attachment of a
separate safety harness approved to BS 6684 (if required).
The points for attachment are located on the aist straps of
the harness.
This product complies ith BS EN 1888 : 2012
For all technical queries please call: 01454 326 568
Imported by:
The Red Kite Baby Co Ltd
35 Lavenham Road
Beeches Industrial Estate
Yate
Bristol
BS37 5QX
General care:
• The correct use and maintenance of this stroller is
essential.
• Do not use excessive force hen folding the stroller. If
you are having problems, fully open the stroller and
repeat the folding procedure.
• Al ays let heels do n as gently as possible hen
mounting and dismounting kerbs.
• Al ays fold the stroller hen going up or do n stairs.
Never bump the buggy over these or similar obstacles.
• In some climates mould and milde can affect the
fabric and rain cover. To avoid this, do not fold the
stroller hen it is et. Leave it open in a ventilated area
until completely dry.
• Al ays store the stroller in a dry place.
• When storing the stroller in the car, never place other
items on top of it.
• Do not exceed the maximum load of 2 kgs in the
shopping basket. (Where provided).
Cleaning:
• Fabric covers and trims may be spot ashed using mild
detergent and arm ater. Leave to dry in a
ventilated area a ay from direct sunlight.
• Avoid leaving your buggy in direct sunlight for
prolonged periods of time as this may cause fabrics
to fade.
• Do not dry clean, machine ash or tumble dry.
• Metal parts may be cleaned ith a damp cloth. Al ays
ipe dry. Clean plastic parts ith a mild soap and
ater solution, ipe dry.
Maintenance:
• Maintain your stroller by lubricating all metal moving
parts ith a light machine oil e.g. WD-40. Do not use
heavy machine oil or grease as this can attract dirt or
grit.
• Check that nothing is loose or broken and that no sharp
edges have been exposed. Inspect all joints and the
harness, replace any damaged parts immediately.
• Inspect any nuts and bolts regularly to ensure none
have orked loose. Tighten as necessary.
• Only use replacement parts and accessories that have
been approved by the manufacturer. Failure to do this
may invalidate your arranty.
IMPORTANT
Keep these instructions for future reference.
Your child’s safety may be affected if you do not follo these instructions.
Instruction Leaflet
Push Me T ini
This vehicle is intended for children from birth up to a maximum eight of 15kgs.
Complies ith BS EN 1888 : 2012
Customer Care Line: 01454 326 568
*Colours may vary

Assembly instructions
To open the chassis
Pull the folding catch to the side and lift the handle up ards
(1a) until the handle locks in place . (1b).
To attach rear heels and functions
Push the stems of the rear heels in to the axle until they
click in place (2). Pull the heel gently to make sure they are
secure. To remove the rear heels, push the silver button in
and pull the heel out ards.
To operate the brakes
With your foot, push the foot pedal on the right side do n
until it clicks in to place (3). Lift up ards to release the
breaks.
WARNING! Ensure that all the locking devices are
engaged before use.
Front heel assembly and functions
Push the front heels on to the front legs of the chassis until
they click into place. Pull them gently to make sure they are
secure. (4).
Push the s ivel catch up to select fixed heels or do n for
s ivel heels.
To remove the front heels you can either push the button in
and pull the heel unit and stem off or you can just remove
the heel unit by pushing the button located on the bottom
of the leg and pull the heel unit off.
Parts List
Parts ListParts List
Parts List
A Chassis
B Front Wheels x 2
C Bumper Bar x 2
D Footmuffs x 2
E Rear wheels x 2
F Raincover
( ot shown)
A
B
C
D
Fig. 1a
Folding catch
Fig. 1b
Fig. 2
Swivel
catch
Fig. 4
Accessories
A raincover is supplied ith this stroller.
The raincover should be placed over the hood and
secured ith the velcro tabs. It should be folded then
placed in the basket hen not is use.
E
Fig. 3
Fig. 5
Fig. 6
Fig. 7
Fig. 11
Fig. 8
A + B
To attach the bumper bars
Push the ends of the bumper bars in to the slots on the chassis
until they ‘click’ in to place. To remove the bars, push in the
buttons on both sides and pull the bars off (5).
Leg rest adjustment
Push the buttons on both sides of the leg rest and select desired
position (6).
To attach the foot covers
Place the end of the leg rest in to the foot cover and rap the
top of the foot cover around the bumper bar (7) and secure ith
the press studs.
To operate the hood
Pull the hood for ard by the front rim of the hood. For added
shade / eather protection, the hood can be unzipped further
as sho n (8).
To operate the seat recline function
Squeeze the clasp on the back of the seat unit and pull
do n ards. When the seat unit has reached the desired
position, release the trigger. To raise the seat unit, hold both
straps ith one hand and push the back of the seat unit ith your
other hand (9).
To adjust and secure the harness
Push the buckle prongs in to the buckle housing until they snap
into position. Adjust sliders to ensure a snug fit for your child.
After making adjustments to the seat al ays re adjust the
harness. Release the harness by pressing the button on the
buckle housing unit.
WARNING! Al ays use the crotch strap in combination ith
the aist belt.
WARNING! For babies aged 0 - 6 months the harness
must be fed through the retaining loops to prevent risk of
strangulation.
To fold the stroller
Make sure the seats are in the upright position, the hood is
retracted and the brakes are engaged. Slide the primary lock
button (A) to the side and then squeeze the secondary lock
button (B). Keep the secondary lock button held in and push up
and for ards on the handle. Fold all the ay do n until the
folding catch locks in place.
Fig. 9
Seat
recline
clasp
Folding catch
Shoulder
straps
Fig. 10
Sliders
Buckle Buckle
Buckle
housing
A (slide)
B (squeeze)