Reid flite pro User manual

BUILD ME
Pages 1-10
RIDE ME
MAINTAIN ME
JOIN THE COMMUNITY
ENVIRONMENTAL PLEDGE
Pages 21-29
Pages 11-20
Pages 36-41
Pages 30-35

OWNER'S PACK
@REIDBIKES
SCAN HERE TO
REGISTER YOUR REID
SCAN HERE TO
REGISTER YOUR REID

1 2
BUILD ME

The scooter is intended for riders older than 16 years. Children shall not play with the appliance. Children should not
play with the Scooter or parts of it nor should cleaning or maintenance be done by children. Do not ride the Scooter if
you suffer from reduced physical, sensorial or mental capabilities. Riders with a lack of experience or knowledge should
drive carefully.
1.
2. This manual can also be downloaded from the website: www.reidbikes.com
3. WARNING: For the purposes of recharging the battery, only use the detachable supply unit provided with this appliance.
4. When product is discarded:
(1) the battery must be removed from the appliance before it is scrapped;
(2) the appliance must be disconnected from the supply mains when removing the battery;
(3) the battery is to be disposed safely
5. This appliance contains batteries that are non-replaceable.
This manual applies to your Reid Flight Pro electric scooter. Please read the manual carefully to ensure that:
You quickly grasp the basic operating procedures and riding methods of your Flight Pro electric scooter.1.
You familiarise yourself with safe driving rules for a safe and enjoyable scooter experience.2.
3. You understand the composition and safety of your Flight Pro electric scooter.
If you have any questions or need more information, please visit www.reidbikes.com
Please pay attention to the following signs and relating content:
Dangers!
Could cause serious property damage or
personal injury
Warnings!
Improper operations can lead to the
malfunction of the product
Information tips
Version Number: A01
About The Manual
3 4
BUILD ME

*Please check carefully that the parts in the package are intact.
What Comes In The Box
5 6
BUILD ME

7 8
BUILD ME
Assembly and Set Up
Fold the handlebar stem up, fasten
it, and put down the kickstand
1. 2. Install the handlebar onto the stem 3. Tighten the screws onto both sides of
the stem with the T-shaped Allen key
4. After the assembly, press the power
button to check if it's working properly.

9 10
BUILD ME
Charging condition description:
The scooter is fully charged when the LED on the charger changes from
RED (charging) to GREEN (trickle charge)
Charging your eScooter Safety Instructions
Your Reid eScooter is a sporting entertainment tool that is not a vehicle. If you drive it into a
public area there are multiple safety risks not just to yourself but also to others. Strictly follow the
instructions in this manual, to protect yours and others safety and to ensure compliance with
national and provincial regulations and traffic regulations. It is important to understand that if
you decide to take your Reid eScooter on a public road or other public place, you may be exposed
to the risk of unauthorised driving / improper operation of your eScooter, even if you are in full
compliance with our safe driving guide. You must strictly follow the safety requirements of this
manual where there are no national standards and regulations for electric scooters. Reid shall not
be liable for any liability, personal injury, accident, legal dispute and all other unfavourable events
resulting from the use of violating the instructions indicated in this manual.
The faster the eScooter is driving, the longer the brakes need and on some smooth surfaces,
using the left-hand brake can cause the wheels to slip and lose balance or even fall. Therefore it is
important to be vigilant and maintain the proper speed during driving, whilst maintaining a
reasonable safety distance to others. Please be vigilant and drive at low speeds before entering
unfamiliar terrain.
Do not lend your Reid eScooter to a person who has never ridden it before to avoid injury. If you
do lend your eScooter to someone, be sure to be responsible for the safety of them, you should
teach them how to ride and tell them of how to ride safely, wearing the right safety gear.
Please check your Reid eScooter every time before driving. If you find that parts are loose, the
battery life is minimum or there is abnormal sound or malfunction, then please stop using it
immediately and do not force it to drive.

RIDE ME
11 12

3. When the scooter starts to coast, put both feet
on the deck and press the accelerator. Note: The
accelerator initiates once the coasting speed
exceeds 5 km/h.
4. When the scooter is at a full stop, the
accelerator automatically turns off. To restart
the scooter, it is necessary to repeat step 2.
5. Release the accelerator and the kinetic
energy recovery system (KERS) initiates
automatically to brake slowly; squeeze the
brake lever for a sudden brake.
6. Tilt your body to the steering direction as
you turn, and slowly turn the handlebar
How To Ride
*There are risks of falling and injury when riding,
so please wear a helmet and protective gear as
shown in the picture.
Turn on the power and check the power indicatior.1. 2. One foot stands on the deck, the other foot kicks
backward.
13 14
RIDE ME

Riding Safely
15 16
RIDE ME
Do not ride in the
rain.
Avoid hitting your head on
door frames, elevators, and
other overhead obstacles.
Do not accelerate when going downhill,
and brake in time to slow down. When
encountering a steep incline, you need to
step off the scooter and push, do not risk
riding up
Keep your speed between 5-10 km/h when
you ride through speed bumps, elevator door
stills, bumpy roads or other uneven surfaces.
Slightly bend your knee to better adjust
mentioned surfaces.
Do not ride in traffic lanes
or residential areas where
vehicles and pedestrians
are both allowed.
Do not ride through puddles
or any other (water)
obstacles. In such a case
please lower your speed and
bypass the obstacle.
Do not ride with
anyone else, including
children
Do not abruptly change the
steering direction at high
speed.

Warning Reminder
Do not try to do any dangerous movements.
17 18
RIDE ME
Do not keep your feet on
the rear Mudguard. Do not try riding up or down stairs, nor try jumping
over obstacles.
Do not let go of the
handlebar while riding.

Folding and Transportation
19 20
RIDE ME
Floding
Handlebar Stem
Safety Hook
Open
The scooter needs to be turned off before folding. Hold the handlebar
stem, turn it counterclockwise to open the safety hook and open the quick
release lever. Align the bell and the buckle and hook them. When opening,
disengage the bell lever from the buckle on the mudguard. Fold the
handlebar stem up, close the quick release lever and turn the handlebar
stem clockwise to close the safety hook.
Hold the handlebar stem with either one hand
or both hands.

MAINTAIN ME
21 22

1. Do not use alcohol, gasoline, kerosene or other corrosive, volatile solvents to clean, otherwise it will seriously damage the body
and internal structure. It is forbidden to use a pressure fun spray and flush. Make sure that the charging cable is unplugged and
the rubber cap has been tightened when cleaning, otherwise it may cause an electric shock or accident due to water intake.
2. Store you Reid eScooter in a dry and cool room as much as possible to avoid accelerating of ageing. Failure to do so will reduce
the usage life of the battery over time.
3. When the scooter is fully charged and not in use, it needs to be recharged every 3 months to avoid battery over-discharge
protection.
Do not remove the battery. Removing the battery is complicated and can alter the operation
of the machine: You can contact an authorized repairer if the product is still guaranteed. If the product is not guaranteed you can
contact any specialized repairer of your choice. You can contact us for customer service
Removing the wheels is complicated and incorrect assembly can lead to instability and malfunctions.
Daily Maintenance
If there is a mark on the body of your Reid eScooter, wipe it with a small amount of water with a soft cloth. If it is difficult to clean,
you can use a toothbrush to brush it repeatedly then use a damp cloth to clean in. If the body has plastic scratches, you can use
sandpaper or other abrasive materials for polishing.
Electric scooter cleaning and storage
23 24
MAINTAIN ME
Adjusting the handlebar:
Prolonged use of the scooter may cause the screws to loosen and the handlebar stem to become
unstable. If you notice that your handlebar stem is wobbling when riding, follow the steps below.
1. In the folded state (see page 12), use tool I to loosen "c" (in the direction of clockwise).
2. Use tool I to loosen "b" (clockwise).
3. Use tool II to adjust "a" (clockwise) to the position
appropriate, and use tool I to tighten "b" (counterclockwise).
4. Raise the stem on the handlebar, close the quick release lever and turn the stem on the
handlebar clockwise to close the snap hook.
5. Shake the handlebar stem to see if the problem has been resolved. If not, repeat steps 2 and 3. If it
has been resolved, continue with step 6.
6. Put the scooter back in the folded state and use tool I to tighten "c"
(counterclockwise).
* Step 6 is mandatory
a. Inner Hex Nut
b. Hex Stud
c. Hex Nut
Tools:
I: 8-10mm wrench
II: 4mm Allen key
Note: These tools must be prepared
by the user.
Do not place the battery in an environment where the ambient temperature is higher than 50°C or lower than -20°C (e.g., do not leave
the scooter or the battery pack in a car under direct sunlight for an extended time). Do not throw the battery pack into fire as it may lead
to battery failure, battery overheating, and even another fire. If the scooter is expected to be left idle for
more than 30 days, please fully charge the battery and place it in a dry and cool place. Keep in mind to recharge it every 60 days to
protect the battery from potential damage which is beyond limited warranty.
Scooter shall be only be used with original batteries and charging of the Scooter shall only
be done by the original charging adapter supplied with the Scooter (or any battery model or charging adapter model approved by the
manufacturer as compatible). Always charge before exhausting the battery to prolong the battery's lifespan. The battery pack performs
better at normal temperature, and poor when it is below 0°C. For instance, when it is below -20°C, the riding range is only half or less at
normal state. When the temperature rises, the riding range restores.

Parameter Table
Data and parameters vary by mode. Subject to change without notice.
Note:
Electric scooters are fully charged, load is 100kg, ambient temperature is 25°C
without wind, maximum speed is 25kph. However, the actual cruising range
varies with driving habit, roads, ambient temperature, wind speed and other
factors.
Height:
The height of the body to the ground.
Endurance:
25 26
MAINTAIN ME
1115*460*1190
1115*460*505
18
16-60
120-200
25
20
40 (General range)
IP54
Approx. 3-4
2.0A
42V
100-240VAC
350W
700W
84W
350Wh
36V
42V

Your eScooter has a 1-year warranty from the date of purchase.
If you’re having an issue with your eScooter, we want to help resolve it. In the first instance,
please contact the store where you purchased the product. If you experience any difficulty
settling a warranty claim with your retailer, please contact us directly. Likewise, should
anything feel loose or not right then please stop using your product immediately and get in
contact with the retailer you purchased it from or us directly.
Register you eScooter with us via the QR code below so we can quickly and easily verify your
purchase for you warranty. Should your eScooter ever be stolen, you can also get in touch
with us to retrieve your serial number which is often wanted by the authorities.
Warning
1.To reduce the risk of injury, user must read the instructions manual.
2. Prolonged exposure to UV rays, rain and the elements may damage the enclosed materials.
3. Store indoors when not in use.
4. Risk of fire, no user serviceable parts
5. Use only with specified charger in instructions
Warranty
27 28
MAINTAIN ME
Battery Care
Never leave batteries charging in a building that is unattended or overnight when you are
sleeping in the property
Unplug or disconnect from the battery once charging is complete
Do not allow the battery to overheat and ensure it is charged on a hard surface where heat can disperse
Monitor and assess for damage to the battery and the charger, following the manufacturer’s guidance for
replacement or repairs
Ensure smoke alarms – preferably interlinked detectors around the property - are fitted where charging is
taking place and, if possible, store and charge away from main living

Error List
E0
Communication Error
E1
Accelerator Error
E2
Battery Error
E3
Motor Phase Error
E4
Controller Error
E5
Motor Hall Error
E6
E-Brake Error
Beep Warnings
Power on or power off
One beep
Mode switch
One beep
Error warning
Error code and beep
Low voltage warning
Two beeps
Enter cruise controller
Three beeps
Error Codes Button Descriptions
28 29
MAINTAIN ME

JOIN THE COMMUNITY
30 31

Instagram
FOLLOW US ON INSTAGRAM
Follow us on Instagram @reidbikes to experience the best of life on two wheels and more. We post
everyday with new products, putdoor adventures and the latest eScooter news! We love sharing
photos from our community of Reid Riders so use #reidbikes and make sure to tag us for your
chance to be featured!
We have dedicated Facebook pages for many of the countries we're found in. These pages will give
you more Reid information specific to your country, so follow us to keep with the all the latest
happenings.
Facebook
FOLLOW US ON FACEBOOK
32 33
JOIN THE COMMUNITY

Subscribe to our Youtube channel for in-depth maintenance and repair guides, as well as the
most inspiring ride videos from around the world to help you plan your next adventure.
We have created a dedicated video series for our eScooters including everything you need to
repair and maintain them. So should you need any help, then make sure to check them out
and ask any questions further questions you may have as we monitor these and reply
regularly.
YouTube
SUBSCRIBE TO OUR YOUTUBE CHANNEL
TikTok
Follow us on TikTok @reidbikes to see new eScooter content, awesome adventure videos from Reid
Riders and the latest TikTok trends!
FOLLOW US ON TIKTOK
34 35
JOIN THE COMMUNITY