REP PR-5000 User manual

PR-5000 with weight storage + lat attachment
parts Included:
2 Uprights
4 Horizontal Braces
8 weight horns
Hardware Included:
4.3 In Bolt
x 24
Nut
x 24
Small Washer
x 44 Bulgy Screw
x 16
1.
If you are starting from an
already assembled rack, remove
the name plate to make room for
the weight storage. If you are
starting with building your
power rack, full PR-5000 Power
Rack Assembly Instructions
available at repfitness.com.
Upright caps must also be
removed so that you can
properly secure any horizontal
braces at the highest point of the
uprights.
Attach horizontal braces to
the top and bottom of each
side of the back of the power
rack. These should be
attached to the highest and
lowest holes of the uprights.
The same screw will be used
that is securing the
horizontal braces of the
power rack.
x4
x8
x4
2.
Connect uprights to horizontal braces.
3.
(4.7 in)
x4
x8
x4
(4.3 in)
Weight Storage Parts + Hardware

Secure weight horns to each
side of weight storage
uprights. Make sure to leave
enough space between each
horn so that the diameter of
the plates can fit vertically in
line with each other.
4.
x4
x8
x4
(3.2 in)
Attach lat crossbars to the top and
bottom of the back of the power
rack. These should be attached to
the highest and lowest holes of the
uprights. They will share the same
screw that is securing the horizontal
braces of the power rack.
5.
x8
x16
x8
(4.7 in)
parts Included:
2 Crossbraces
Top Pulley Brace
Bottom Pulley Brace
Bottom Foot
Weight Peg Crossbrace
Straight Bar Attachment
Lat Pull-Down Attachment
2 Poles
2 Pole Tubes
3 Carabiners
11.5  Cable
10.2  Cable
Hardware Included:
4.7 In Bolt
x 8 3.2 In Bolt x 2
2.8 In Bolt
x 4
1.8 In Bolt
x 3
3.2 In Bolt +
Stoppers
x 3
Nut
x 20
Washer
x 44
.8 In Bolt
x 4
Pulley
x 6
Lat Attachment Parts + Hardware

Secure pulley top and
base braces to crossbars.
6.
x2
x12
x6
(3.2 in)
(3.2 in)
x4
(2.8 in)
(2.8 in)
(2.8 in)
Feed cables through pulleys and secure the
pulleys in their designated locations. One end of
each cable will attach to the base of the lat pull
down to create a line of tension and the other
will have a carabiner to attach pull-down
accessories.
4.
x3
x3
x12
x6
(3.2 in)
(3.2 in)
(3.2 in)
(1.8 in)
(1.8 in)
(1.8 in)
(10.2 )
(11.5 )
Clip your pull-down accessories to the carabiners.
5.