REP RR-4000 ARES User manual

TROUBLESHOOTING GUIDE

ASSEMBLY TOOLS

STEP #1 –Loosen Rack Components
STEP #1A –Upper Crossmembers & Front Upper Bracket (25-0970)
STEP #1B –Logo Plate Crossmember & Upper Rear Brace (25-0971)
Loosen hardware to allow a good amount of movement

STEP #1C –Lower Crossmembers & Front Lower Bracket (25-0966 &
25-0988)

STEP #2 –Loosen Ares Components
STEP #2A –Lat Pull Bracket (25-0968) & Upper Cross Brace (25-0983 &
25-0984)
STEP #2B –Top Outer Bracket (25-0977 & 25-0979)
Loosen hardware to allow a good amount of movement

STEP #2C –3-Pulley Bracket (25-0973 & 25-0975)

STEP #3 –Adjust & Tighten Rack Components
STEP #3A –Lock Tension In Weight Stack
STEP #3B –Lower Rear Crossmember
Press headplate flush with weight stack + place weight pin at bottom of stack
Apply upward tension to the crossmember while tightening hardware

STEP #3C –Lower Front Crossmember & Front Lower Bracket
STEP #3D –Upper Rear Crossmember
Apply upward tension to the crossmember while tightening rear hardware; follow
same process for Front Lower Bracket and front hardware
Apply upward tension to the crossmember while tightening hardware

STEP #3E –Upper Front Crossmember & Front Upper Bracket
STEP #3F –Logo Plate Crossmember
Apply downward tension to the crossmember while tightening rear hardware; follow
same process for Front Upper Bracket and front hardware
Apply downward tension to the Logo Plate Crossmember while tightening hardware

STEP #3G –Upper Rear Brace
Apply downward tension to the Logo Plate Crossmember while tightening hardware

STEP #4 –Adjust & Tighten Ares Components
STEP #4A –3-Pulley Bracket
STEP #4B–Top Outer Bracket
Apply upward tension to the 3-Pulley Bracket while tightening hardware
Apply downward tension to the Top Outer Bracket while tightening hardware

STEP #4C –Upper Cross Brace
STEP #4D –Lat Pull Bracket
Apply downward tension to the Upper Cross Brace while tightening hardware
Apply backward tension to the Lat Pull Bracket while tightening hardware

STEP #4C –Release Weight Stack Tension
STEP #4D –Lat Pull Bracket
Apply downward tension to the Upper Cross Brace while tightening hardware
Apply backward tension to the Lat Pull Bracket while tightening hardware

STEP #4E –Release Weight Stack Tension
Place weight pin at headplate (top of weight stack)
DONE!