RH Baby&child BELLE TWIN DAYBED User manual

BELLE TWIN DAYBED INSTRUCTIONS
ASSEMBLY INSTRUCTIONS:
PA R TS INCLUDED:
A [1]
B [1]
C [1]
D [1]
E [3]
F [2]
TOOLS NEEDED:
Phillips Head Screwdriver (not included)
BACK SECTION
LEFT SIDE SECTION
RIGHT SIDE SECTION
SIDE RAIL
STRETCHER BARS
TOP FLATFORM PANELS
1
2
3
4
5
Page 1 of 3
Bolts 5/16” x 2-1/2” 4 pcs.
Spring Washers 5/16”
Flat Washers 5/16”
Allen Key 4mm
Screws 8 x 30mm
4 pcs.
4 pcs.
4 pcs.
15 pcs.
6Screws 8 x 25mm 3 pcs.
NO. ITEM DESCRIPTIONQTY.
Note:
- Bed must be assembled by at least two people.
- Please read instructions carefully before assembling bed.
- Use the above parts and fittings list to identify each component.
- Keep all packing materials until assembly is complete to avoid loss of smaller parts.
STEP 1:
Place the hooks of the Left/ Right Side Sections (B,C) into the slots in the Back Section (A). If necessary, using a thick
magazine or book to protect the Left/ Right Side Sections (B,C), hammer with a mallet or hammer until tight.
C
B
A

Page 2 of 3
BELLE TWIN DAYBED INSTRUCTIONS
STEP 2:
Attach the Side Rail (D) to the Left/ Right Side Sections (B,C) by aligning pre-installed wooden dowels and pre-drilled
holes on Side Rail (D) with the pre-drilled holes on the Left/ Right Side Sections (B,C).
STEP 3:
Attach the Left/ Right Side Sections (B,C) to the Side Rail (D), and to Back Section (A) by using Bolts (1), Spring Washers
(2), Flat Washers (3) and tighten with Allen Key (4).
D
D
C
C
B
B
2
1
3
4
A

Page 3 of 3
BELLE TWIN DAYBED INSTRUCTIONS
D
A
E
5
Phillips Head
Screwdriver (not included)
STEP 4:
Lay the Stretcher Bars (E) in between the Side Rail (D) and
Back Section (A).
- Attach the Stretcher Bars (E) to the Side Rail (D) with using
Screws (5).
- Attach the Stretcher Bars (E) to the Stretcher of the Back
Section (A) with Screws (6).
- Tighten all screws by using Phillips Head screwdriver.
STEP 5:
Lay the Top Platform Panels (F) on top of the Stretcher
Bars (E) and attach using Qty. 12 Screws (5) with
Phillips head screwdriver. 12x
5
3x
3x
Phillips Head
Screwdriver (not included)
6
1. Dust often using a clean, soft, dry lint-free cloth.
2. Blot spills immediately, and wipe with a clean, damp cloth.
3. We do not recommend the use of chemical cleansers,
abrasives, or furniture polish on our lacquered finish.
CARE INSTRUCTIONS: