RH Baby&child RH TEEN HENNING User manual

HENNING DESK CHAIR - ASSEMBLY INSTRUCTIONS
A. CHAIR TOP (1)
B. SWIVEL PLATE (1)
C. GAS LIFT (1)
D. 5-ARM BASE (1)
E. CASTERS (5)
1. Carefully unpack all parts and remove plastic coverings.
asMM ASSEMBLY INSTRUCTIONS
PARTS INCLUDED
2. Put the 5-Arm Base (D) on a flat surface with the top down.
(Note: Cover the work surface with a protective material to
prevent damage to it and the chair base.)
3. Attach the Casters (E) underneath the 5-Arm Base (D) as shown in the sketch.
4. Repeat step 3 with the 5-Arm Base (D) and the other Casters (E).
5. Turn the chair base upright.
6. Remove the blue plastic dust cover cap from the top of the Gas Lift (C) and
attach it to the 5-Arm Base (D).
7. Attach the Swivel Plate (B) to the assembled base.
8. Position the assembled base underneath the Chair Top (A) and align the holes
on the Swivel Plate (B) with the holes on the chair.
9. Attach the seat to the base so that the height-adjusting handle is on the right
side when sitting down.
10. Insert the Allen-Head Bolts (1) and Flat Washers (2) into the holes. Tighten using
the Allen Wrench (3).
11. Adjust the chair's height by pulling up on the trigger at the bottom of the Chair
Top (A) as shown in the sketch.
12. Assembly is complete.
Allen-Head Bolts
Flat Washers
Allen Wrench

1. Clean periodically by wiping the chair lightly with a soft, clean cloth.
asMM
CARE INSTRUCTIONS
2. Do not use abrasive cleaners, as they may damage the finish.
HENNING DESK CHAIR - ASSEMBLY INSTRUCTIONS