FLATIRON FLOOR LAMP
IMPORTANT SAFETY INSTRUCTIONS
For safety purposes, this lamp is equipped with a polarized plug (one
blade is wider than the other). If the plug does not fit securely into
outlet, do not force it - contact a professional electrician. Use the
plug with an extension cord only if it can be fully inserted into the
cord’s socket. Never alter the plug in any way.
This fixture has been rated for one (1) 100-Watt maximum TYPE A
standard bulb (not included) OR one (1) 23-Watt compact fluorescent
bulb (not included) or one (1) 4.5-Watt SBLED light bulb (included).
To avoid the risk of fire, do not exceed the recommended wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the light bulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS IS NOT A TOY AND THE PRODUCT HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 ft away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3.
ASSEMBLY & INSTALLATION
1. Carefully remove all parts from the box and remove all plastic
covering.
2. Join Round Column (D), Lamp Base (E), and Base Weight
(F) together; slide Washer (G) over the threaded pipe, which
protrudes from bottom of Base Weight (F).
3. Screw Nut (H) onto the threaded pipe to secure Lamp Base (G)
to Round Column (D). Tighten with Wrench (K).
4. Remove backing sheet from Felt Paper (J) and affix Felt Paper (J)
underneath the Base Weight (F).
5. Insert Harp (B) into the Harp Saddle (C).
6. Unscrew the Finial (A) from the Harp (B) and place the desired
shade (not included) over the Harp (B).
7. Attach the Finial (A) and tighten to secure the shade.
8. Insert Bulb (L) into threaded socket.
9. Plug into proper electrical outlet and test fixture.
10. Assembly is complete.
CARE INSTRUCTIONS
Do not use polishes or cleaners on your lamp. Just wipe clean with
a soft cloth.
