RH INDIAN FORTRESS BED User manual

COMPONENTS
(1) HEADBOARD X 2PC
Left Frame - A
Right Frame - B
INDIAN FORTRESS BED ASSEMBLY INSTRUCTIONS
Hardware Included :
(2) WOODEN CLEAT X 1PC
NUMBER OF PERSONS TO ASSEMBLE - 3 TO 4 APPROX TIME TO ASSEMBLE: 15 TO 25 MINUTES
Page1 of 5
BOLT M15 x 150 mm (9)
FLAT WASHER - 20 mm Dia (10)
WRENCH - M14, M15 (12)
1 PC
9 PCS
2 PCS
SCREW - 100 mm (8) 6 PCS
Professional Installation Required
SCREW NUT - M15 (11) 1 PC
(3) FOOT BOARD X 1 PC
(4) SIDE RAIL X 2PC
(5) CENTER SUPPORT X 1PC
(6) SLAT SUPPORT X 2PC
ALLEN KEY (7) 1 PC
BOLT M10 x 100 mm (13) 8 PCS
SCREW NUT - M12 (14) 8 PCS
WRENCH - M12, M13 (15) 1 PC

STEP - 1
WALL
STEP - 3
Page2 of 5
Measure the mounting height on the wall by measuring the height of the hardware fitted
at the back of the headboard such that the headboard rests on the floor.
Lift the headboard part (A) and (B) and align the Headboard cleats with wall cleat (2)
to secure the headboard (both parts A & B) to the wall with the headboard resting on the
floor.
2
8
7
FLAT WALL
A
B
2
1
If wall has baseboard molding then
remove wooden bar from bottom corners
of the headboard using Allen key (7).
A
B
2
1
If wall is flat then there is no need to
remove wooden bar.
WALL with Skirting
WOODEN CLEAT
STEP - 2
Fix the wooden cleat (2) on the wall using screw (8) into wall studs.

STEP - 4
STEP - 5
Page 3 of 5
For stabilizing both parts of headboard (A) and (B), put Bolt (9) into the slot provided at
bottom of headboard to fix it with flat Washer (10), Screw Nut (11) and Wrench (12).
910 11
12
Tighten Bolt (13) by hand in Headboard (1) and Footboard (3) to attach side rails.
1
13
13
1
3

Page 4 of 5
STEP - 6
Attach the side rails (4) to the headboard (1) and footboard (3) to the headboard
bolt with the flat washers (11), screw nuts (14) and wrench (15) on all four
corners of bed as shown in the picture.
4
3
114
11
STEP - 7
Fix the Center Support (5) in the Headboard (1) and Footboard (3) Slots as shown
in the picture.
5
15

Page 5 of 5
STEP - 8
Fix the slat support (6) on the Center support (5) and Side rails (4) as shown in
picture.
STEP - 9
Assembly completed.