RH THADDEUS Programming manual

THADDEUS MIRROR 30" (76CM) X 40" (102CM)
ASSEMBLY AND INSTALLATION INSTRUCTIONS
ENGLISH

(A)
(B)
(C)
THADDEUS MIRROR 30" (76CM) X 40" (102CM) ENGLISH
REVISION 03-31-2023 RH.COM
THADDEUS MIRROR 30" (76CM) X 40" (102CM)
PART LIST
1. Mirror
HARDWARE LIST
(A) Hangman Wall Bracket 24" (61cm) (1)
(B) Hangman Wall Bracket 18" (46cm) (1)
(C) Screw (12)
TOOL AND MATERIALS REQUIRED
(1) Screwdriver
(2) Pencil
(3) 3/8 Drill Bit (for wall anchor)
(4) Hand Drill
(5) Carpenter Level

THADDEUS MIRROR 30" (76CM) X 40" (102CM) ENGLISH
REVISION 03-31-2023 RH.COM
BEFORE YOU BEGIN
1. Be sure to check all packaging materials carefully for small parts
that may have become loose during shipment and place all parts
on a non-abrasive surface.
2. Professional installation recommended.
STORAGE
1. Do not stack anything on top of the mirror.
2. Keep the mirror packaged until installation.
3. Store mirror upright on the long edge.
MIRROR HANDLING INSTRUCTIONS
CAUTION
1. Remove vertically from package
2. Always carry mirror vertically as illustrated. Carrying flat will cause
breakage.
SAFETY INSTRUCTIONS
1. Professional installation is strongly recommended.
2. For your safety, it is recommended that two people hang the fixture.
3. These instructions are provided for your safety. They must be read
carefully and completely before the installation of the fixture.
4. Check with a professional installer to ensure your wall can tolerate a
fixture with two times the weight of the mirror.
NOTE: For safe mounting, it is important to use the proper
hardware for your wall type. The included hardware is for
stud mounting only. If the mounting bracket cannot be
secured to a wall stud because of inappropriate spacing
and/or because you have a different wall type (e.g., plaster,
concrete, brick, etc.) please consult your local hardware
store for fastener advice.

2
WALL
STUD
MIRROR
FRAME
MIRROR
BRACKET
HANGMAN BRACKET
SCREW
NOGGINS
STUDS STUDS
THADDEUS MIRROR 30" (76CM) X 40" (102CM) ENGLISH
REVISION 03-31-2023 RH.COM
WARNING
1. These mirror parts can be cumbersome to some people, therefore
the assistance of two or more people is recommended to prevent
personal injury and ensure the mirror is not damaged during the
assembly process.
2. Serious injury or death can occur if the mirror is not hung correctly.
Do not use wire to hang. Please follow the correct hanging
methods for the wall type. Consult a professional before hanging.
HERE ARE SOME GUIDELINES AS FOLLOW
1. If the wall is CONCRETE/MASONRY, drill a hole on each mark and
then insert a plastic wall anchor on each hole. Use a screwdriver to
attach the bracket to the wall.
2. If the mirror wall bracket will be installed on DRYWALL ALONG
WITH THE STUDS use a screw to fasten the wall bracket.
3. If the mirror wall bracket will be installed only on the DRYWALL, use
hollow wall anchors to fasten the bracket.
ASSEMBLY INSTRUCTIONS
1. According to your preference, you can conveniently install this
mirror in a landscape or portrait position. Pre-set the mirror on your
desired location and mark the location with a light pencil mark. Use
tape or pencil to transcribe the location of the wall into the mirror
bracket.
2. Hold the bracket against the wall and check the alignment of both
ends of the bracket that has the same distance on the floor or
ceiling surface.
3. After checking the level, fasten the brackets against the wall with
screws provided in your hardware packed. Please see FIGURE 01.
4. Install the mirror on the wall bracket as illustrated in FIGURE 02.
DRY WALL WITH STUDS
Screw inserted directly into stud
CONCRETE/MASONRY
DRYWALL WITHOUT AVAILABLE
WOOD STUD
Plug with wall anchor
FIGURE 01
FIGURE 02

THADDEUS MIRROR 30" (76CM) X 40" (102CM) ENGLISH
REVISION 03-31-2023 RH.COM
WARRANTY
If you are not completely satisfied with your purchase, please contact
us to return or exchange your item(s) within 30 days of the delivery
date, with proof of purchase. Note that returns or exchanges are not
accepted for special orders, items that have been installed, mattresses
and/or foundations no longer in their original packaging, and other
items listed below. Other exclusions may apply. Contact us for details.
Unfortunately, galleries cannot accept returns of furniture or other large
items.
CLEANING INSTRUCTIONS
To maintain and protect the luster of all product clean with a soft damp
cloth only.

THADDEUS MIRROR 36" (91CM) X 48" (122CM)
ASSEMBLY AND INSTALLATION INSTRUCTIONS
ENGLISH

(A)
(B)
(C)
THADDEUS MIRROR 36" (91CM) X 48" (122CM) ENGLISH
REVISION 03-31-2023 RH.COM
THADDEUS MIRROR 36" (91CM) X 48" (122CM)
PART LIST
1. Mirror
HARDWARE LIST
(A) Hangman Wall Bracket 24" (61cm) (1)
(B) Hangman Wall Bracket 18" (46cm) (1)
(C) Screw (12)
TOOL AND MATERIALS REQUIRED
(1) Screwdriver
(2) Pencil
(3) 3/8 Drill Bit (for wall anchor)
(4) Hand Drill
(5) Carpenter Level

THADDEUS MIRROR 36" (91CM) X 48" (122CM) ENGLISH
REVISION 03-31-2023 RH.COM
BEFORE YOU BEGIN
1. Be sure to check all packaging materials carefully for small parts
that may have become loose during shipment and place all parts
on a non-abrasive surface.
2. Professional installation recommended.
STORAGE
1. Do not stack anything on top of the mirror.
2. Keep the mirror packaged until installation.
3. Store mirror upright on the long edge.
MIRROR HANDLING INSTRUCTIONS
CAUTION
1. Remove vertically from package
2. Always carry mirror vertically as illustrated. Carrying flat will cause
breakage.
SAFETY INSTRUCTIONS
1. Professional installation is strongly recommended.
2. For your safety, it is recommended that two people hang the fixture.
3. These instructions are provided for your safety. They must be read
carefully and completely before the installation of the fixture.
4. Check with a professional installer to ensure your wall can tolerate a
fixture with two times the weight of the mirror.
NOTE: For safe mounting, it is important to use the proper
hardware for your wall type. The included hardware is for
stud mounting only. If the mounting bracket cannot be
secured to a wall stud because of inappropriate spacing
and/or because you have a different wall type (e.g., plaster,
concrete, brick, etc.) please consult your local hardware
store for fastener advice.

2
WALL
STUD
MIRROR
FRAME
MIRROR
BRACKET
HANGMAN BRACKET
SCREW
NOGGINS
STUDS STUDS
THADDEUS MIRROR 36" (91CM) X 48" (122CM) ENGLISH
REVISION 03-31-2023 RH.COM
WARNING
1. These mirror parts can be cumbersome to some people, therefore
the assistance of two or more people is recommended to prevent
personal injury and ensure the mirror is not damaged during the
assembly process.
2. Serious injury or death can occur if the mirror is not hung correctly.
Do not use wire to hang. Please follow the correct hanging
methods for the wall type. Consult a professional before hanging.
HERE ARE SOME GUIDELINES AS FOLLOW
1. If the wall is CONCRETE/MASONRY, drill a hole on each mark and
then insert a plastic wall anchor on each hole. Use a screwdriver to
attach the bracket to the wall.
2. If the mirror wall bracket will be installed on DRYWALL ALONG
WITH THE STUDS use a screw to fasten the wall bracket.
3. If the mirror wall bracket will be installed only on the DRYWALL, use
hollow wall anchors to fasten the bracket.
ASSEMBLY INSTRUCTIONS
1. According to your preference, you can conveniently install this
mirror in a landscape or portrait position. Pre-set the mirror on your
desired location and mark the location with a light pencil mark. Use
tape or pencil to transcribe the location of the wall into the mirror
bracket.
2. Hold the bracket against the wall and check the alignment of both
ends of the bracket that has the same distance on the floor or
ceiling surface.
3. After checking the level, fasten the brackets against the wall with
screws provided in your hardware packed. Please see FIGURE 01.
4. Install the mirror on the wall bracket as illustrated in FIGURE 02.
DRY WALL WITH STUDS
Screw inserted directly into stud
CONCRETE/MASONRY
DRYWALL WITHOUT AVAILABLE
WOOD STUD
Plug with wall anchor
FIGURE 01
FIGURE 02

THADDEUS MIRROR 36" (91CM) X 48" (122CM) ENGLISH
REVISION 03-31-2023 RH.COM
WARRANTY
If you are not completely satisfied with your purchase, please contact
us to return or exchange your item(s) within 30 days of the delivery
date, with proof of purchase. Note that returns or exchanges are not
accepted for special orders, items that have been installed, mattresses
and/or foundations no longer in their original packaging, and other
items listed below. Other exclusions may apply. Contact us for details.
Unfortunately, galleries cannot accept returns of furniture or other large
items.
CLEANING INSTRUCTIONS
To maintain and protect the luster of all product clean with a soft damp
cloth only.