17. Connect 48 sets of crystal links kit (L) for the third tier. Hang the
crystal links kit around the third tier.
18. Connect 32 sets of crystal links kit (L) for the fourth tier. Hang the
crystal links kit around the fourth tier.
19. Connect 16 sets of crystal links kit (L) for the fifth tier. Hang the
crystal links kit around the fifth tier.
20. Insert the recommended bulbs into sockets.
21. Assembly is complete.
IMPORTANT PLEASE READ
Page 3 of 3
SAFETY INSTRUCTIONS:
Exercise care and precaution when moving furniture, as careless
handling may cause injury and damage.
Never drag furniture. Always lift when moving.
Periodically check all fixtures to ensure none have come loose.
Re-tighten when necessary. Incorrect assembly of furniture can be
dangerous.
No liability will be accepted for damage or injury caused by
incorrectly assembled furniture.
Heavy item warning.
Take care and seek assistance when lifting heavy furniture to avoid
personal injury and/or damage to product.
CARE INSTRUCT IONS:
Keep your marble top free of dust and dirt will minimize
scratches and wear pattern that can from the everyday use
Clean your marble top on a regular basis with warm water and
a clean, non-abrasive cloth, sponge, or mop, in addition, using
a neutral cleaner specifically formulated for natural stone will
help remove soils that normal dusting or damp mopping leave
behind.
Do not use general purpose cleaner or you may damage your
marble or the sealer applied. Do not use products that contain
lemon, vinegar, or other acids as these may etch the marble
surface of damage the polish. Do not use scouring powders
or creams; these products contain abrasives that may scratch
the surface. products that contain bleach should not be used
to clean your marble surfaces.
ASSEMBLY INSTRUCTIONS:
TORANO MARBLE ROUND COFFEE TABLE
1. Please find the corresponding numbered parts before
you assemble the unit.
2. Place marble top (A) on a flat floor covered with a
protective material to prevent damage to the marble top.
Place base (B) onto the marble top, keep marble top
position blocks on the underside of the top between legs
to prevent marble top from moving in horizontal direction.
3. The base will align with the wood inserts in the underside
of the tabletop, secure using screws (1) and flat washers
(2). Place all bolts in position first, then tighten with
screwdriver. Pilot holes are not required.
4. Cover screw holes with rubber plug (3).
5. Assembly is complete.
6. Adjust levelers as necessary.
