Rigid Industries E Series User manual

Yamaha
®
yxz
®
2016-2017 Yamaha
®
yxz
®
Roof Mount Installation Instructions
Fits (1) 38" E-Series®
kit includes
(2) Mounts #46575
*Lights Sold Separately
Thank you for purchasing Rigid Industries® products for your Yamaha®. Installation is fairly simple
with the right tools and good mechanical abilities. If you are not condent in your mechanical
skills, please seek the help of a professional to perform the installation. Please read through all
of these instructions and tips before proceeding with the installation.
It is strongly recommended that this product be installed by a professional.
Important
step 1
Remove (2) factory bolts under roof and re-install bolts through Rigid Industries roof mount.
See Figure 1.
Figure 1 Figure 1.1
Always disconnect any power sources connected to your
vehicle before servicing fuses or electrical systems.

Follow us on facebook at
Facebook.com/RigidIndustries
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 • www.rigidindustries.com
For warranty information, visit www.rigidindustries.com/about/warranty
WARRANTY INFORMATION
Your installation is now complete.
Welcome to the Rigid Nation!
PKG-IS-205-A
E-Series and Rigid Industries are registered and/or common law marks owned by
JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.
step 2
step 3
Repeat Step 1 for remaining side.
Wiring: Wire your lights according to the instructions included with the light. Take care to
avoid any heat sources and sharp or abrasive surfaces.
Install Rigid Industries light using hardware provided with the light. See Figure 3.
Figure 3