Rigid Industries SR Series User manual

polaris ranger grille
2012-2013 polaris®ranger®
grille installation instructions
10" SR-Series®
It is strongly recommended that this product be installed by a professional.
Installation of this product requires cutting of your factory installed grille.
Your factory grille will be unusable after it has been cut.
This product may have more surface area than your factory grille. It may
reduce airow. Reduction in airow can potentially lead to overheating
or other mechanical issues.
important
kit includes
(1) Mounting Bracket
®
Always disconnect any power sources connected to your
vehicle before servicing fuses or electrical systems.
*Lights Sold Separately

installation instructions
1. Remove the existing lower grille by unscrewing
bolts on either side.
2. Secure Rigid Industries® 10” SR-Series® light in
bracket using mount hardware provided with the
light. The ¼” threaded studs on the sides of the
light will slide into slots on the bracket. Don’t fully
tighten nuts at this time – you will want to adjust
the light angle after it is installed on the vehicle.
3. Mount the new grille with the light installed
where the lower grille was removed. Secure with
the original bolts.
4. Wire your lights according to the instructions
included with the light(s). Take care to avoid any
heat sources and sharp or abrasive surfaces.
5. Once your lights are wired, position your vehicle
on a at surface, facing a wall. Adjust aim on your
lights so that the beam is pointing in the vertical
direction you want.
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 ext 1008 • www.rigidindustries.com
Follow us on facebook at
facebook.com/RigidIndustries
IS-40340 REV2
Your installation is now complete.
Welcome to the Rigid Nation!
Warranty Periods:
• All LED Lights – Limited Lifetime
• Accessories and Mounts – 2 years
Warranty Coverage:
To begin your warranty claim, you must have a Return Merchandise Authorization (RMA) number. To get your
RMA number, please contact our warranty department by phone at 480-655-0100 ext. 1008, or by lling out the
Return Merchandise Authorization Form on our website.
All of the following will immediately void all warranties:
• Customer negligence – The customer has modied the light and/or is not using it for the recommend application.
• Customer abuse – Damage to the light beyond normal wear and tear.
• Repair work done by unauthorized personnel without Rigid Industries’approval.
• If the light has been opened or any screws have been removed.
All warranties are non-transferable. Warranty terms and policies are subject to change without notice.
*For all information regarding the Rigid Industries’Limited Lifetime Warranty please call 855-760-5337 ext. 1008, email
[email protected], or visit our warranty page online at rigidindustries.com/about/warranty.
• Flashlights – 1 year
• Batteries – 90 days
Rigid Industries warrants that this product will be free from defects in material and workmanship. If
you believe your Rigid Industries product is defective, it must be returned to Rigid Industries for
inspection by our warranty claims department. If, after inspection, Rigid Industries veries that the
defect was not caused by negligence, abuse, unauthorized repair or disassembly, Rigid Industries will
determine whether the product will be repaired or replaced in accordance with Rigid Industries
Limited Lifetime Warranty*.
Warranty Information
Rigid Industries, Rigid, and SR-Series are registered and/or unregistered trademarks of JST Performance, Inc. d/b/a Rigid Industries.