Rigid Industries HOOD MOUNT 46549 User manual

Can-am
®
maverick
®
X
®
DS
2014-2016 can-am
®
maverick
®
X
®
DS
kit includes
(1) Single-Piece Mount #46549
(3) 1/4-20 x 5/8” Hex Head Self Drilling Screw
HOOD MOUNT
Installation Instructions
Fits (1) 10" SR-Series®
*Light sold separately
Thank you for purchasing Rigid Industries® products for your Can-Am®. Installation is fairly simple
with the right tools and good mechanical abilities. If you are not condent in your mechanical skills,
please seek the help of a professional to perform the installation. Please read through all of these
instructions and tips before proceeding with the installation.
It is strongly recommended that this product be installed by a professional.
Important
Always disconnect any power sources connected to your
vehicle before servicing fuses or electrical systems.
step 1
Draw a line on all three hood tabs, ush to
the hood brace (use the hood brace as a
guide) before removing the hood.
See Figure 1.
Figure 7.
Figure 1

step 3
Cut factory zip tie holding vent tubes on the square bar under the hood.
See Figure 3.
step 2
Remove hood then tape o the three
marked tabs. Use tape as guide to cut
tabs o. Remove tabs.
See Figure 2.
Figure 7.
Figure 2
Figure 2.1 Figure 7. Figure 2.2
Figure 3

step 5
Install Rigid Industries mount with (3) 1/4-20 X 5/8” Hex Head Self-Drilling Screw.
See Figure 5.
step 4
Center Rigid Industries mount and mark
(3) 1/8” holes to be drilled.
See Figure 4.
Figure 7.
Figure 4
Figure 4.1 Figure 7. Figure 4.2
Figure 5

Follow us on facebook at
Facebook.com/RigidIndustries
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 • www.rigidindustries.com
PKG-IS-184-A
Rigid Industries, Rigid, SR-Series, are registered and/or common law marks owned by
JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.
For warranty information, visit www.rigidindustries.com/about/warranty
WARRANTY INFORMATION
Your installation is now complete.
Welcome to the Rigid Nation!
Wiring: Wire your lights according to the instructions included with the light.
Take care to avoid any heat sources and sharp or abrasive surfaces.
step 6
Install Rigid Industries light using hardware provided with the light.
See Figure 6.
Figure 6 Figure 7. Figure 6.1