RIOTEC FS5103A User manual

1
Programming Quick Guide
- FS5103A
Installation
Reset Configuration to Default :
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan A1 to A2 for USB HID or B1 for RS232 /
USB Serial. This will reset the scanner to its factory defaults.
USB HID RS232 / USB Serial.
A1 B1
A2
*Note : Please install PL-2303 driver for USB serial
Keyboard Language (For USB HID only)
Scan the appropriate country code as below to program the
keyboard layout for your country or language. As a general
rule, the following characters are supported, but need special
care for countries other than the United States:
@ | $ # { } [ ] = / ‘ \ < > ~
USA
(Original setting)
Italian
Norway France
Germany Vietnam
Sweden Spain
Denmark
P
ortu
g
al
Switzerland Hun
g
ary
1D Symbologies – 1
ENABLE CODABAR DISABLE
ENABLE Code 39 DISABLE
ENABLE Code 32
DISABLE
ENABLE
Code 39
FULL ASCII
DISABLE
ENABLE Interleaved 25 DISABLE
ENABLE Code93 DISABLE
ENABLE Matrix 25 DISABLE
ENABLE IATA 25 DISABLE

2
1D Symbologies – 2
ENABLE CODE 11 DISABLE
ENABLE ISBT 128 DISABLE
ENABLE GS1-128 DISABLE
ENABLE TELEPEN DISABLE
ENABLE UPC-A DISABLE
ENABLE EAN-13 DISABLE
ENABLE EAN-8 DISABLE
1D Symbologies – 3
ENABLE MSI DISABLE
ENABLE
GS1
Omnidirectional DISABLE
ENABLE
GS1 DataBar
Limited DISABLE
ENABLE
GS1 DataBar
Expanded DISABLE
ENABLE CHINA POST DISABLE
ENABLE PLESSY CODEL DISABLE
ENABLE INDUSTRIAL 25 DISABLE
 Information in this document is subject to change without notice.
 For more information, please visit:
www.riotec.com.tw
R_200326_01